RBK 825 Recumbent Bike - Experience™ Series - Precor

Installing the Console 29Completing the Console Installation (P80)Before you complete the final installation steps, double-checkthe connections you have made. Make sure that all cables arefully and securely connected, and that any unneeded cablesare tied back properly.To complete the installation:1. Feed extra cable back into the neck tube.2. Tilt the control console backward (toward yourself) untilthe tab on the top edge of its back plate slides along thetop edge of the console mount and the screw holes alignproperly.3. Insert the four ⁵₈-inch flat head screws through the holesin the console mount and thread them into the holes inthe back plate on the console. Partially tighten the screwsusing a ⁵₈-inch hex wrench.4. Line up the two small tabs at the top of the console’s backcover with the slots at the top of the opening in theconsole case. Insert the tabs into the slots.5. Insert the remaining tabs on the back cover with thecorresponding slots on the console case.6. Press gently on the edges of the back cover to snap it intoplace.Threading the Cable Assembly (P30 andP20)Earlier in the installation, you threaded the necessary cablesthrough the frame of the base unit and out the passthroughopening in the console mount. As you line up the back plateon the console with the console mount, you must make surethat the cable assembly passes correctly through theopenings in both components.Important: Before you begin the following procedure, remove therear cover from the control console. Set the cover and its mountinghardware aside for later use.To thread the cable assembly:1. Make sure that as much of each cable as possible passesthrough the opening in the middle of the console mounton the base unit.2. Position the console over the console mount.