Download PDF - SMC Pneumatics (Ireland)

Series ZSE80/ISE80Specific Product Precautions 2Be sure to read this before handling.Refer to the back of page 1 for Safety Instructions and “Precautions for HandlingPneumatic Devices” (M-03-E3A) for Pressure Switches Precautions.Caution1. Mounting with panel mount adapterFront protection cover (Option)MountingFront protection cover (Option)PanelPanelPanel mountadapter APanel mountadapter APanel mountadapter BPanel mountadapter B2. Mounting with bracketsMount a bracket to the using two M3 x 5L mounting screws and install on piping. The switch can be installed horizontally dependingon the installation location.Mounting screw M3 x 5LMounting screw M3 x 5LBracket ABracket BThe tightening torque for bracket mountingscrew should be 0.98 N·m or less.CautionSet Pressure Range and Rated Pressure RangeSet the pressure within the rated pressure range.The set pressure range is the range of pressure that is possible in setting.The rated pressure range is the range of pressure that satisfies the specifications (accuracy, linearity, etc.) on the switch.Although it is possible to set a value outside the rated pressure range, the specifications will not be guaranteed even if the value stays withinthe set pressure range.SwitchPressure range–100 kPa 0 100 kPa 1 MPa 2 MPaFor vacuumpressureZSE80–101 kPa–111 kPa010 kPaFor compoundpressureZSE80F–110 kPa–100 kPa100 kPa110 kPaFor positivepressureISE80ISE80H–0.1 MPa1 MPa–0.105 MPa 1.1 MPa–0.1 MPa–0.105 MPa2 MPa2.2 MPaBack page 3Rated pressure range of switchSet pressure range of switch