Installation Instructions - Clipsal

More documents

Recommendations

Info

Intelligent Building SeriesC-Bus 12 Channel Professional Architectural Dimmer Installation Instructions5.3 Connecting LoadsAn internally mounted terminal block is provided for the connection of wiring forthe loads. As shown in the above table the terminal block can accommodateload cable wiring of 4.0mm 2 wire diameter.Below is a diagram of the inside of the C-Bus 12 Channel ProfessionalArchitectural Dimmers. The Supply and Load terminal blocks are on the righthand side of the unit.© Copyright 2003 Clipsal Integrated Systems Pty Ltd. Page 10
Intelligent Building SeriesC-Bus 12 Channel Professional Architectural Dimmer Installation InstructionsFor each channel there is provided an Active, Neutral and Earth terminal. Thisterminal block can accommodate load wiring of 4.0mm 2 wire or 2 x 2.5mm 2wire.WARNING1. Do not wire dimmer channels in parallel.2. Load terminals are not isolated when the output is in the OFF state.3. A maximum of 80 C-Bus 12 Channel Professional Architectural Dimmerscan be connected to a single network.4. Do not short dimmer channel output to neutral or earth.© Copyright 2003 Clipsal Integrated Systems Pty Ltd. Page 11
Page 1 and 2: C-Bus 12 Channel Professional Archi
Page 3 and 4: Intelligent Building SeriesC-Bus 12
Page 9: Intelligent Building SeriesC-Bus 12
Page 31 and 32: Intelligent Building Series C-Bus 1

Installation Instructions - Clipsal

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?