Installation Instructions - Clipsal

Intelligent Building SeriesC-Bus 12 Channel Professional Architectural Dimmer Installation Instructions6.13 Minimum Output Channel LevelThe level that is output on the load may have a minimum level set. In this way aminimum brightness level for each channel can be assigned, such that the loadwill not dim below the selected minimum output channel level. This feature isvery useful for loads that are to remain on at a minimum setting, regardless ofthe control level. For situations where turning on large loads causes thebreakers to trip, due to large in-rush currents, a minimum brightness setting canbe used to pre-heat the filament to reduce the turn-on in-rush current.To view the minimum output channel level when LO shows in the display, pressthe SET button. All 12 channel LEDs will flash. Press a channel button to viewthe minimum output channel level for that channel. Press CONTROL to returnto the previous menu.To change a minimum output level, press the SET button whilst a minimumoutput channel level is being displayed. The century digit will flash. Press achannel button in the range 1..9 or 0, or press the SET button to leave thecurrent value. Repeat for the tens and units value. You may press theCONTROL button at any time while a digit is flashing to cancel the change.You may enter a number in the range 0..100.6.14 Maximum Output Channel LevelThe level that is output on the load may have a maximum level set. In this way amaximum brightness level for each channel can be assigned, such that the loadwill not dim above the selected maximum output channel level. This feature isvery useful for loads that are not required to be run at full brighness and formatching brightness intensities between different load types.To view the maximum output channel level when HI shows in the display, pressthe SET button. All 12 channel LEDs will flash. Press a channel button to viewthe maximum output channel level for that channel. Press CONTROL to returnto the previous menu.To change a maximum output level, press the SET button whilst a maximumoutput channel level is being displayed. The century digit will flash. Press achannel button in the range 1..9 or 0, or press the SET button to leave thecurrent value. Repeat for the tens and units value. You may press theCONTROL button at any time while a digit is flashing to cancel the change.You may enter a number in the range 0..100.© Copyright 2003 Clipsal Integrated Systems Pty Ltd. Page 19