MSQ - SMC Pneumatics (Ireland)

Series MSQRotary Table Precations 4Be sure to read before handling.CautionShock Absorber1. Refer to the table below for tightening torques of the shockabsorber setting nut.Size 10 20 30 50 70 100 200Tightening torqueN . 1.6710.862.8m3.14 23.52. Never rotate the bottom screw of the shock absorber. (It is not anadjustment screw.) This may cause oil leakage.CautionExternal Shock AbsorberThe threaded orifices shown below are not connecting ports. Neverremove the plugs as this will cause malfunction.Bottom screw cannot be rotatedThreaded orifices3. When rotation of the rotary table with internal shock absorber isset at a value smaller than the table below, the piston strokebecomes smaller than the shock absorber's effective stroke andenergy absorption capacity decreases.SizeMinimum rotation without energyabsorption capacity decrease4. Products with shock absorber are not designed to smooth stop butto absorb the kinetic energy of the load. If the load has to bestopped smoothly, a shock absorber of the optimum size meetingthe operating conditions must be installed external to theequipment.5. Shock absorbers are consumable parts. When a decrease inenergy absorption capacity is noticed, it must be replaced.With internal shock absorberSize1020305070100200With external shock absorberSize TypeFor low energy10For high energyFor low energy20For high energyFor low energy30For high energyFor low energy50For high energy10 20 30 50 70 100 20052 43 40 60 71 62 82 Shock absorber modelRBA0805-X692RBA1006-X692RBA1411-X692RBA2015-X821RBA2725-X821Shock absorber modelRB0805RB0806RB1006RB1007RB1006RB1007RB1411RB1412Speed Controller and FittingsCautionSize 1, 2, and 3 use M3 x 0.5 piping ports. When connecting a speedcontroller or fittings directly, use the following series.Speed controllerAS121F/Elbow typeAS131F/Universal typeOne-touch fittingOne-touch miniature fittings Series K JMiniature fittings Series M3Auto switchCautionIn case of sizes 1, 2, 3 and 7, when 2 pieces of auto switches areinstalled in one switch groove, the minimum detectable rotationangles are as follows.Size1237CautionMinimum detectable rotation25 25 20 20 Maintenance and InspectionBecause sizes 1, 2, 3 and 7 require special tools, they cannot bedisassembled.Because sizes 10, 20, 30 and 50 have the table press fit into anangular type bearing, they cannot be disassembled.36