NVR user manual - Kamery IP

For example, when you turn on the NVR with 5 hard drives installed, the LCD panelshows:C o n f i g . D i s k s ?→ R A I D 5You can press the “Select” button to browse more options, e.g. RAID 6.Press the “Enter” button and the following message shows. Press the “Select”button to select “Yes” to confirm.C h o o s e R A I D 5 ?→ Y e s N oWhen you execute RAID 1, RAID 5, or RAID 6 configuration, the system will initializethe hard drives, create the RAID configuration, format the RAID configuration, andmount it as a volume on the NVR. The progress will be shown on the LCD panel.When it reaches 100%, you can access the RAID volume, e.g. create share foldersand upload files to the folders on the NVR. In the meantime, to make sure thestripes and blocks in the RAID configuration are ready, the NVR will execute RAIDsynchronization and the progress will be shown on the “Disk Management” >“Volume Management” page. The synchronization rate is around 30-60 MB/s(varied by hard disk drive models, system resource usage, etc.).Note: If a member drive of the RAID configuration was lost during thesynchronization, the RAID volume will enter degraded mode. The volume data isstill accessible. If you add a new member drive to the volume, the volume will startto rebuild. You can check the status on the “Volume Management” page.When the configuration has finished, the server name and the IP address will beshown. If the NVR fails to create the disk volume, the following message will beshown.C r e a t i n g . . .R A I D 5 F a i l e d188