NVR user manual - Kamery IP

More documents

Recommendations

Info

2.2 Hard Disk Drives Compatibility ListThis product works with 2.5-inch/3.5-inch SATA hard disk drives from popular harddisk brands. For the HDD compatibility list, please visithttp://www.qnapsecurity.com/pro_compatibility.aspQNAP disclaims any responsibility for product damage/malfunction or dataloss/recovery due to misuse or improper installation of hard disks in any occasionsfor any reasons.2.3 IP Cameras Compatibility ListFor the information of supported IP camera models, please visithttp://www.qnapsecurity.com/pro_compatibility_camera.asp26
2.4 Check System StatusLED Display & System Status OverviewLED Colour LED Status DescriptionFlashes greenand redalternatelyevery 0.5 sec1) The hard drive on the NVR is beingformatted2) The NVR is being initialised3) The system firmware is beingupdated4) RAID rebuilding is in process5) Online RAID Capacity Expansion isin process6) Online RAID Level Migration is inprocessSystemStatusRed/GreenRed1) The hard drive is invalid2) The disk volume has reached its fullcapacity3) The disk volume is going to be full4) The system fan is out of function*5) An error occurs when accessing(read/write) the disk data6) A bad sector is detected on thehard drive7) The NVR is in degraded read-onlymode (2 member drives fail in aRAID 5 or RAID 6 configuration, thedisk data can still be read)#8) (Hardware self-test error)Flashes redevery 0.5 secThe NVR is in degraded mode (onemember drive fails in RAID 1, RAID 5or RAID 6 configuration)*Flashes greenevery 0.5 sec1) The NVR is starting up2) The NVR is not configured3) The hard drive is not formattedGreenThe NVR is readyOffAll the hard drives on the NVR are instandby modeOrangeThe NVR is connected to the networkLANOrangeFlashesorangeThe NVR is being accessed from thenetwork27
Page 1 and 2: VioStor NVRNetwork Video RecorderUs
Page 3 and 4: Important Notice• Reading instruc
Page 5 and 6: Table of ContentsTABLE OF CONTENTS
Page 7 and 8: 6.5.1 Create user..................
Page 9 and 10: Safety Warning1. This product can o
Page 11 and 12: Chapter 1.Introduction1.1 OverviewQ
Page 13 and 14: 1.2.2 VS-8040/VS-8032/VS-80241. One
Page 15 and 16: 1.2.4 VS-5020/VS-50121. One touch a
Page 17 and 18: 1.2.6 VS-4016 Pro/VS-4012 Pro/VS-40
Page 19 and 20: 1.2.8 VS-2012 Pro/VS-2008 Pro1. One
Page 21 and 22: 1.2.10 VS-201P/V1. One touch auto v
Page 23 and 24: 1.2.12 VS-101P/V1. One touch auto v
Page 25: Security Settings of the Web Browse
Page 29 and 30: Beep Alarm (beep alarm can be disab
Page 31 and 32: 3. Finder detects the VioStor serve
Page 33 and 34: 7. After the quick configuration, y
Page 35 and 36: Chapter 3.Use VioStor by Local Disp
Page 37 and 38: 3.1 Quick ConfigurationIf the NVR h
Page 39 and 40: 4. Enter the date and time settings
Page 41 and 42: To manually add an IP camera or edi
Page 43 and 44: 7. Verify the settings and click
Page 45 and 46: IconDescriptionMonitor:Click this i
Page 47 and 48: PTZ Control PanelThe term “PTZ”
Page 49 and 50: Live View ScreenUpon successful con
Page 51 and 52: Note:1. Enabling or disabling manua
Page 53 and 54: Playback Settings:You can play, pau
Page 55 and 56: 2. Enter the user name and password
Page 57 and 58: System configuration:Login the syst
Page 59 and 60: c. PTZ: Pan/Tilt/Zoom camera contro
Page 61 and 62: Camera StatusThe camera status is i
Page 63 and 64: 4.2.4 Multi-server MonitoringFollow
Page 65 and 66: You can configure the following set
Page 67 and 68: 4. Click the number buttons to view
Page 69 and 70: 8. After configuring the auto cruis
Page 71 and 72: 5.1.1 Connect to Server for Playbac
Page 73 and 74: 3. Configure servers:a. Add: Add a
Page 75 and 76: • Timeline searchi. Select the NV
Page 77 and 78:
• Event entryi. Select the NVR se
Page 79 and 80:
vi.Event search. This function is p
Page 81 and 82:
5.1.2 Play Video Files from Your Co
Page 83 and 84:
Play the video of four IP camerasSe
Page 85 and 86:
2. On the playback window, click .8
Page 87 and 88:
6. Define the detection zone. Mouse
Page 89 and 90:
8. Click “Search” to start sear
Page 91 and 92:
5.1.5 Convert to AVI FileYou can sa
Page 93 and 94:
4. Enter the recording type.5. Spec
Page 95 and 96:
5.2 Digital WatermarkingVioStor NVR
Page 97 and 98:
6. Click to start playing and expor
Page 99 and 100:
Clickto start checking the files. T
Page 101 and 102:
5.3.1 Windows Network Neighbourhood
Page 103 and 104:
Chapter 6.System AdministrationTo l
Page 105 and 106:
If the NVR is has not been configur
Page 107 and 108:
Step 3. Enter the date, time, and t
Page 109 and 110:
Step 6. Initialize the IP camera se
Page 111 and 112:
6.2 System SettingsYou can configur
Page 113 and 114:
6.2.3 View System SettingsYou can v
Page 115 and 116:
If your NVR supports two LAN ports,
Page 117 and 118:
• Load balancingLoad balancing en
Page 119 and 120:
• Secondary DNS ServerEnter the I
Page 121 and 122:
6.3.3 File ServicesYou can enable t
Page 123 and 124:
6.3.5 Protocol ManagementTo assign
Page 125 and 126:
6.4 Device ConfigurationYou can con
Page 127 and 128:
To create a RAID 5 disk volume, ami
Page 129 and 130:
• Configure spare driveThis funct
Page 131 and 132:
6.4.4 UPSYou can connect a UPS (uni
Page 133 and 134:
3. userThe general users have only
Page 135 and 136:
6.5.2 Edit UserSelect a user on the
Page 137 and 138:
13. Change the cameraaccess control
Page 139 and 140:
Note:1. All the settings will not t
Page 141 and 142:
6.6.2 Recording SettingsSelect a ca
Page 143 and 144:
6.6.3 Schedule SettingsYou can sele
Page 145 and 146:
Note: All the settings will be effe
Page 147 and 148:
• Events:The events supported by
Page 149 and 150:
(2) Motion detectionThis option all
Page 151 and 152:
(6) External event (user-defined ev
Page 153 and 154:
• Actions:The NVR supports differ
Page 155 and 156:
(1) RecordingSelect the channels (I
Page 157 and 158:
(3) Alarm outputSelect to activate
Page 159 and 160:
(5) SMSTo allow the system administ
Page 161 and 162:
(7) User-defined ActionYou can ente
Page 163 and 164:
• Pre-/Post-alarm Recordings• S
Page 165 and 166:
6.7.2 SMSC SettingsYou can configur
Page 167 and 168:
6.7.3 Restart/Shut DownFollow the s
Page 169 and 170:
• Enable front video backup butto
Page 171 and 172:
6.7.5 System UpdateQNAP provides ne
Page 173 and 174:
6.7.6 Backup/Restore/Reset Settings
Page 175 and 176:
2. Enable remote replication (suppo
Page 177 and 178:
8. The NVR displays the latest 10 r
Page 179 and 180:
179
Page 181 and 182:
6.7.11 Advanced System SettingsYou
Page 183 and 184:
6.8.3 On-line Users ListThis page s
Page 185 and 186:
Chapter 7.System MaintenanceThis se
Page 187 and 188:
Chapter 8.LCD Panel* This section i
Page 189 and 190:
View the system information by the
Page 191 and 192:
4. SystemThis section shows the sys
Page 193 and 194:
Chapter 9.Troubleshooting1. The mon
Page 195 and 196:
8. The monitoring screen shows hori
Page 197 and 198:
Registration ProcedurePlease follow
Page 199 and 200:
4. Configure the mailing lists if n
Page 201 and 202:
Environment 2: VioStor and the IP c
Page 203 and 204:
Environment 3: VioStor and the IP c
Page 205 and 206:
Technical SupportQNAP provides dedi
Page 207 and 208:
Developers that use the GNU GPL pro
Page 209 and 210:
the work with that Major Component,
Page 211 and 212:
License and any conditions added un
Page 213 and 214:
If you convey an object code work u
Page 215 and 216:
licenses granted under the third pa
Page 217 and 218:
and under the terms of this License
Page 219:
COPYRIGHT HOLDERS AND/OR OTHER PART
show all

NVR user manual - Kamery IP

Create successful ePaper yourself

Delete template?

Save as template?