NVR user manual - Kamery IP

To allow a remote PC to connect to VioStor and the IP cameras, you need to:Step 1. Set up the port mapping (virtual server) on the router.FromForward to219.87.144.205:8000 192.168.1.1:80219.87.144.205:8001 192.168.1.101:80219.87.144.205:8002 192.168.1.102:80219.87.144.205:8003 192.168.1.103:80Step 2. Add the IP camera to VioStor by entering the IP address of the IP camera inthe “IP Address” settings. Enter the public IP address of the router and the mappedports of the IP camera in the “WAN IP Address” settings.Note: When configuring the IP camera, the WAN IP and LAN IP must be entered.To open FTP (port 21) and SMB (port 445) of VioStor on WAN, configure thefollowing port mapping settings:FromForward to219.87.144.205:21 192.168.1.1:21219.87.144.205:139 192.168.1.1:139219.87.144.205:445 192.168.1.1:445After finishing the above two steps, you can access VioStor over WAN by enteringthe IP address http://219.87.144.205:8000 in the IE browser. Then login VioStorwith the correct user name and password.If the port specified to VioStor is 80, you can enter http://219.87.144.205 to accessVioStor as the default port of HTTP is 80.Note: If the router does not use a fixed IP, you will need to configure the DDNSsettings on the router. Other configurations are the same as above.202