Automotive Refinishing Policy Manual - Sacramento Metropolitan Air ...

777 12 TH STREET, 3 RD FLOOR SACRAMENTO METROPOLITANAIR QUALITYMANAGEMENT DISTRICTSACRAMENTO, CA 95814AUTHORITY TO CONSTRUCT(CONTINUED)C. To inspect any equipment, operation, or method required in this Authority to Construct, andD. To sample emissions from the source or require samples to be taken.[Basis: SMAQMD Rule 201, Section 405]3. This Authority to Construct does not authorize the emission of air contaminants in excess of thoseallowed by Division 26, Part 4, Chapter 3, of the California Health and Safety Code or the Rules andRegulations of the Sacramento Metropolitan Air Quality Management District.[Basis: SMAQMD Rule 201, Section 405]4. The equipment shall not discharge such quantities of air contaminants or other materials which causeinjury, detriment, nuisance or annoyance to any considerable number of persons or to the public, orwhich endanger the comfort, repose, health, or safety of any such persons or the public, or which cause,or have a natural tendency to cause, injury or damage to business or property.[Basis: SMAQMD Rule 402, Section 301]5. A legible copy of this Authority to Construct shall be maintained on the premises with the equipment.[Basis: SMAQMD Rule 201, Section 401]EMISSION LIMITATIONS6. The coating operation shall not discharge into the atmosphere any visible air contaminants other thanuncombined water vapor, for a period or periods aggregating more than three minutes in any one hour,which are as dark or darker than Ringelmann No. 1 or equivalent to or greater than 20% opacity.[Basis: SMAQMD Rule 401, Section 301]7. Emissions from the coating operation shall not exceed the following limits:[Basis: SMAQMD Rule 201, Section 405 and Rule 202, Section 301 and Section 410.2]Pollutant (A)Maximum Allowable Emissions(lb/day) (lb/quarter) (lb/year)VOC 861.8 (B) 4,700 4,700PM10 2.8 (C) 15 (C) 15 (C)PM2.5 2.8 (C) 15 (C) 15 (C)(A) Definitions: VOC is volatile organic compound as defined in SMAQMD Rule 101, GeneralProvisions and Definitions. PM10 is particulate matter with an aerodynamic diameter of 10 micronsor less. PM2.5 is particulate matter with an aerodynamic diameter of 2.5 microns or less.(B) Based on a coating spray rate of 6.3 gallons/hour (Binks HVLP gun maximum spray rate),maximum VOC content of 5.7 lb/gallon (Based on Rule 459 maximum standards) and operating 24hours/day.(C) Uncontrolled PM10 emission factor of 6.4 lb PM10/ton of VOC emitted is from AIRS FacilityPAGE 2 of 10THIS IS NOT A PERMIT TO OPERATEA/C NO.:XXXXX