Automotive Refinishing Policy Manual - Sacramento Metropolitan Air ...

More documents

Recommendations

Info

777 12 TH STREET, 3 RD FLOOR SACRAMENTO METROPOLITANAIR QUALITYMANAGEMENT DISTRICTSACRAMENTO, CA 95814AUTHORITY TO CONSTRUCT(CONTINUED)C. To inspect any equipment, operation, or method required in this Authority to Construct, andD. To sample emissions from the source or require samples to be taken.[Basis: SMAQMD Rule 201, Section 405]3. This Authority to Construct does not authorize the emission of air contaminants in excess of thoseallowed by Division 26, Part 4, Chapter 3, of the California Health and Safety Code or the Rules andRegulations of the Sacramento Metropolitan Air Quality Management District.[Basis: SMAQMD Rule 201, Section 405]4. The equipment shall not discharge such quantities of air contaminants or other materials which causeinjury, detriment, nuisance or annoyance to any considerable number of persons or to the public, orwhich endanger the comfort, repose, health, or safety of any such persons or the public, or which cause,or have a natural tendency to cause, injury or damage to business or property.[Basis: SMAQMD Rule 402, Section 301]5. A legible copy of this Authority to Construct shall be maintained on the premises with the equipment.[Basis: SMAQMD Rule 201, Section 401]EMISSION LIMITATIONS6. The coating operation shall not discharge into the atmosphere any visible air contaminants other thanuncombined water vapor, for a period or periods aggregating more than three minutes in any one hour,which are as dark or darker than Ringelmann No. 1 or equivalent to or greater than 20% opacity.[Basis: SMAQMD Rule 401, Section 301]7. Emissions from the coating operation shall not exceed the following limits:[Basis: SMAQMD Rule 201, Section 405 and Rule 202, Section 301 and Section 410.2]Pollutant (A)Maximum Allowable Emissions(lb/day) (lb/quarter) (lb/year)VOC 861.8 (B) 4,700 4,700PM10 2.8 (C) 15 (C) 15 (C)PM2.5 2.8 (C) 15 (C) 15 (C)(A) Definitions: VOC is volatile organic compound as defined in SMAQMD Rule 101, GeneralProvisions and Definitions. PM10 is particulate matter with an aerodynamic diameter of 10 micronsor less. PM2.5 is particulate matter with an aerodynamic diameter of 2.5 microns or less.(B) Based on a coating spray rate of 6.3 gallons/hour (Binks HVLP gun maximum spray rate),maximum VOC content of 5.7 lb/gallon (Based on Rule 459 maximum standards) and operating 24hours/day.(C) Uncontrolled PM10 emission factor of 6.4 lb PM10/ton of VOC emitted is from AIRS FacilityPAGE 2 of 10THIS IS NOT A PERMIT TO OPERATEA/C NO.:XXXXX
777 12 TH STREET, 3 RD FLOOR SACRAMENTO METROPOLITANAIR QUALITYMANAGEMENT DISTRICTSACRAMENTO, CA 95814AUTHORITY TO CONSTRUCT(CONTINUED)Subsystem Source Classification Codes and Emission Factor Listing for Criteria Air Pollutants, EPA450/4-90-003 (March 1990). The PM10 emission factor is assumed to be all PM2.5.8. Compliance with the coating emissions limitation in Condition No. 7 shall be determined as follows:[Basis: SMAQMD Rule 201, Section 405]VOC Emissions = [Coating Usage (A) , gal/quarter] x [VOC as applied (VOC actual) (B) , lb/gal] +(lb/quarter) [Surface Preparation and Cleanup Solvent Usage, gal/quarter] x [VOC, lb/gal](A) Coating usage includes thinner, reducers, hardeners, retarders, catalysts, activators and additives.(B) VOC actual is the actual content weight of volatile organic compounds per total volume of the coatingas defined in Rule 459, Section 408.VOC Emissions = Sum of VOC Emissions [Quarters 1, 2, 3 & 4](lb/year)EQUIPMENT OPERATION9. Vehicle Coating Limits: A person shall not apply to any motor vehicle, mobile equipment, or associatedparts and components, any coating with a VOC Regulatory content in excess of the following limits.[Basis: SMAQMD Rule 459, Section 301]Coating Category(SMAQMD Rule 459 Definition)Maximum VOC Regulatory Content asAppliedgrams/liter (lb/gal)Adhesion Promoter 540 (4.5)Clear Coating 250 (2.1)Color Coating 420 (3.5)Multi-Color CoatingA. Mobile equipment driven or drawn on rails and itsassociated parts and componentsB. Any other mobile equipment or motor vehicle and itsassociated parts and components520 (4.3)680 (5.7)Pretreatment Coating 660 (5.5)Primer/Primer Sealer 250 (2.1)Single-Stage Coating 340 (2.8)Temporary Protective Coating 60 (0.5)PAGE 3 of 10THIS IS NOT A PERMIT TO OPERATEA/C NO.:XXXXX
Page 1 and 2: Automotive, Truck and Heavy Equipme
Page 3 and 4: Materials for Vehicles - The requir
Page 5 and 6: 2. State Requirementsa. California
Page 7 and 8: Temporary Protective Coating 60 (0.
Page 9 and 10: Administrative/Recordkeeping Requir
Page 11 and 12: 4. New Source Review -- Emission Of
Page 13 and 14: - Supplied with manufacturer’s em
Page 15 and 16: 777 12th Street, 3rd Floor SACRAMEN
Page 17 and 18: Authority to Construct EvaluationA/
Page 24 and 25: Exhibit VI-BSample Authority to Con
Page 28 and 29: 777 12 TH STREET, 3 RD FLOOR SACRAM
Page 36 and 37: 777 12 TH STREET, 3 RD FLOOR (916)
Page 44: 777 12 TH STREET, 3 RD FLOOR (916)

Automotive Refinishing Policy Manual - Sacramento Metropolitan Air ...

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?