Automotive Refinishing Policy Manual - Sacramento Metropolitan Air ...

Materials for Vehicles – The requirements of section 303 shall not apply to any motor vehicle,mobile equipment, or associated parts and components coating operations at a stationarysource with actual emissions from such operations less than 2.7 tons of VOC prior toemissons control equipment per 12-month rolling period.4. Data FormsThe following forms must be completed by the person submitting an application (these forms areused by the District to characterize the type of product to be coated, coatings and materials to beused, booth size/flow rates, filtration and exhaust control devices):Form G100: Application for Authority to Construct and/or Permit to Operate (2 pages)Form G101: General Information FormForm AC100: Automotive Coating Operations (Coating and Solvent Usage form included)Form HRA100: Health Risk Assessment Analysis Information FormC. COMPLETENESSThe following information is needed to make this determination:1. The Authority to Construct application form completely filled out and the initial permit fee mustaccompany the forms. (see Section D below).2. The applicable forms listed in Section B must be completely filled out by the applicant.3. Any additional information needed to calculate the emissions from the source, and to quantifyemissions from the proposed source(s) of offsets (if applicable).4. Any additional information needed to complete a health risk assessment.D. FEES1. New Automotive Refinishing Operations• Coating Operations with a Paint Spray Booth: Use Schedule 1 (see Rule 301, Section308.2). Fees are based on the rated horsepower of the exhaust fan on the booth. Use theInitial Permit Fee column for new installations or equipment not previously permitted.• Coating Operations without a Paint Spray Booth: Use Schedule 9 (see Rule 301, Section308.10)• Coating operations with a booth and associated dryer use either schedule 1 or 2, whicheverresults in a higher fee2. Modifications:• For modifications of permitted equipment resulting in an increase in the compressor’shorsepower, the fee is assessed in accordance with fee schedule 1 (Rule 301, Section308.2), based on the incremental increase in horsepower resulting from such change (seeRule 301,Section 306.1)• For modifications resulting in no increase in the exhaust fan’s horsepower, the fee shall bebased on Rule 301, Section 306.2.3. Installed Without an Authority to Construct (Existing Equipment):• As per Section 302.1 of Rule 301, any person installing/operating regulated equipmentwithout obtaining a permit from the SMAQMD first, will be required to pay permit renewalback fees for each year of unpermitted operation, to a maximum of 3 years, in addition tothe initial permit fee.E. REGULATIONSAutomotive Refinishing operations within the jurisdiction of the SMAQMD may be subject to some or all ofthe following rules and regulations. The type of operation, size of source, potential to emit, and otherfactors will dictate which rules are appropriate for a refinishing application. Other rules may also apply.1. SMAQMD Rules and Regulations (please refer to the actual rules for applicability andcompliance determinations):a. Rule 102 -- Circumvention:VI-2