Automotive Refinishing Policy Manual - Sacramento Metropolitan Air ...

More documents

Recommendations

Info

777 12 TH STREET, 3 RD FLOOR SACRAMENTO METROPOLITANAIR QUALITYMANAGEMENT DISTRICTSACRAMENTO, CA 95814AUTHORITY TO CONSTRUCT(CONTINUED)FrequencyInformation To Be Recordedgrams per liter, calculated pursuant to SMAQMD Rule 459, Section 408.c. The weight percentage of volatiles, water and exempt compounds.d. The volume percentage of water and exempt compounds.e. The density of the material (in grams per liter).f. For coatings and coating components containing tertiary butyl acetate, theactual content of tertiary butyl acetate per total volume of coating or coatingcomponent, expressed in grams per liter.ii. For each individual ready to spray mixture (based on the manufacturer’s andrepackager’s stated mix ratio):a. The volatile organic compound regulatory content for coatings expressed ingrams per liter, calculated pursuant to SMAQMD Rule 459, Section 407.b. The volatile organic compound actual content for coatings expressed ingrams per liter, calculated pursuant to SMAQMD Rule 459, Section 408.c. The weight percentage of volatiles, water and exempt compounds.d. The volume percentage of water and exempt compounds.e. The density of the material (in grams per liter).f. For each ready to spray mixture containing tertiary butyl acetate, the actualcontent of tertiary butyl acetate per total volume of the mixture, expressed ingrams per liter.iii. For coating removers and solvents subject to Condition No. 10:a. The volatile organic compound content as calculated pursuant to SMAQMDRule 459, Section 409.MonthlyQuarterly andAnnuallyF. Monthly purchase records identifying the coating type, name/code/manufacturer,and purchased volume of each material (gal/month).G. For coatings containing tertiary butyl acetate, monthly records regarding use,including name/code/manufacturer of the coating and content of tertiary butylacetate contained in each coating.H. Calculation of VOC emissions from the coating operations by the method specifiedin Condition No. 8 (lb/quarter & lb/year).18. The permittee shall, upon determination of applicability and written notification by the District, comply withall applicable requirements of the <strong>Air</strong> Toxics “Hot Spots” Information and Assessment Act (CaliforniaHealth and Safety Code Section 44300 et seq.).[Basis: SMAQMD Rule 201, Section 303.1]PAGE 6 of 10THIS IS NOT A PERMIT TO OPERATEA/C NO.:XXXXX
777 12 TH STREET, 3 RD FLOOR SACRAMENTO METROPOLITANAIR QUALITYMANAGEMENT DISTRICTSACRAMENTO, CA 95814AUTHORITY TO CONSTRUCT(CONTINUED)NATIONAL EMISSION STANDARDS FOR HAZARDOUS AIR POLLUTANTS: PAINT STRIPPING ANDMISCELLANEOUS SURFACE COATING OPERATIONS (40 CFR 63 SUBPART HHHHHH)Applicability: This regulation applies to paint stripping operations that involve the use of chemical strippersthat contain methylene chloride (MeCl), Chemical Abstract Service number 75092, in paint removal processesand/or autobody refinishing operations that encompass motor vehicle and mobile equipment spray-appliedsurface coating operations.If spray applied coatings do not contain chromium (Cr), lead (Pb), manganese (Mn), nickel (Ni), orcadmium (Cd), and you have filed a petition for exemption, and have received written confirmationfrom the U.S. Environmental Protection Agency (U.S. EPA) approving your petition, and also do notperform paint stripping activities using methylene chloride (MeCl), then your source is not subject tothis NESHAP (40 CFR 63 Subpart HHHHHH) or any of the following conditions (Condition Nos. 20-29).NOTIFICATIONS19. Initial Notification: The source shall notify the U.S. EPA, no later than 180 days from initial startup, thatthe facility is subject to the standards and if not yet in compliance, when the source will be in complianceby submitting an initial notification form.[Basis: 40 CFR 63 Subpart HHHHHH, Section 63.11175(a)]20. Notice of Compliance: The source shall be in compliance with the applicable requirements upon startup.The source must certify in the initial notification whether the source is in compliance with each of therequirements of this subpart. The source is not required to submit a separate notification of compliancestatus in addition to the initial notification.[Basis: 40 CFR 63 Subpart HHHHHH, Sections 63.11175(a)(8) and 63.11175(b)]GENERAL21. All spray painting must be performed inside a spray booth or prep station with a roof and at least threewalls or curtains (when refinishing vehicle subassemblies), or a roof and four complete walls or completeside curtains (when refinishing complete vehicles or mobile equipment) and must be ventilated so that airis drawn into the booth. The exhaust must be equipped with a filter system that is designed to capture atleast 98% of paint overspray.[Basis: 40 CFR 63 Subpart HHHHHH, Section 63.11173(e)2(i) - 63.11173(e)2(iii)]22. Spray guns used in the coating operation must be one of the following types:A. High Volume Low Pressure (HVLP)B. ElectrostaticC. Any other equivalent spray method demonstrated to achieve transfer efficiency equal to one of theother allowed types of spray guns, which has been approved in writing by the <strong>Air</strong> Pollution ControlOfficer, and submitted to and approved by the U.S. EPA.PAGE 7 of 10THIS IS NOT A PERMIT TO OPERATEA/C NO.:XXXXX
Page 1 and 2: Automotive, Truck and Heavy Equipme
Page 3 and 4: Materials for Vehicles - The requir
Page 5 and 6: 2. State Requirementsa. California
Page 7 and 8: Temporary Protective Coating 60 (0.
Page 9 and 10: Administrative/Recordkeeping Requir
Page 11 and 12: 4. New Source Review -- Emission Of
Page 13 and 14: - Supplied with manufacturer’s em
Page 15 and 16: 777 12th Street, 3rd Floor SACRAMEN
Page 17 and 18: Authority to Construct EvaluationA/
Page 24 and 25: Exhibit VI-BSample Authority to Con
Page 26 and 27: 777 12 TH STREET, 3 RD FLOOR SACRAM
Page 36 and 37: 777 12 TH STREET, 3 RD FLOOR (916)
Page 44: 777 12 TH STREET, 3 RD FLOOR (916)

Automotive Refinishing Policy Manual - Sacramento Metropolitan Air ...

Create successful ePaper yourself

Delete template?

Save as template?