Automotive Refinishing Policy Manual - Sacramento Metropolitan Air ...

More documents

Recommendations

Info

777 12 TH STREET, 3 RD FLOOR (916) 874-4800SACRAMENTO, CA 95814-1908 FAX (916) 874-4899SACRAMENTO METROPOLITANAIR QUALITY MANAGEMENT DISTRICT8. Compliance with the coating emissions limitation in Condition No. 7 shall be determined as follows:[Basis: SMAQMD Rule 201, Section 405]VOC Emissions = [Coating Usage (A) , gal/qtr][VOC As Applied (VOC Actual) (B) , lb/gal] +(lb/qtr)[Surface Preparation and Cleanup Solvent Usage, gal/qtr][VOC, lb/gal](A) Coating usage includes thinner, reducers, hardeners, retarders, catalysts, activators, additives,gasket/gasket sealing material, cavity wax, deadener, and lubricating wax/compound.(B) VOC Actual is the actual content weight of volatile organic compounds per total volume of the coatingas defined in Rule 459, Sec. 408.VOC Emissions = Sum of VOC Emissions (Quarters 1, 2, 3, & 4)(lb/year)EQUIPMENT OPERATION9. Vehicle Coating Limits: A person shall not apply to any motor vehicle, mobile equipment, or associatedparts and components, any coating with a VOC Regulatory content in excess of the following limits.[Basis: SMAQMD Rule 459, Section 301]Coating Category(SMAQMD Rule 459 Definition)Maximum VOC Regulatory Content asAppliedgrams/liter (lb/gal)Adhesion Promoter 540 (4.5)Clear Coating 250 (2.1)Color Coating 420 (3.5)Multi-Color CoatingA. Mobile equipment driven or drawn on rails and itsassociated parts and componentsB. Any other mobile equipment or motor vehicle and itsassociated parts and components520 (4.3)680 (5.7)Pretreatment Coating 660 (5.5)Primer/Primer Sealer 250 (2.1)Single-Stage Coating 340 (2.8)Temporary Protective Coating 60 (0.5)Truck Bed Liner Coating 200 (1.7)Underbody Coating 430 (3.6)Uniform Finish Coating 540 (4.5)Any other coating type, excluding materials listed in Rule459, Section 302250 (2.1)PAGE 3 OF 9 PAGESREVOCABLE AND NON-TRANSFERABLEPERMIT NOS.: XXXXX
777 12 TH STREET, 3 RD FLOOR (916) 874-4800SACRAMENTO, CA 95814-1908 FAX (916) 874-4899SACRAMENTO METROPOLITANAIR QUALITY MANAGEMENT DISTRICT10. A person shall not use the following material on any vehicle if the VOC content exceeds the following limit:[Basis: SMAQMD Rule 459, Sections 309 and 310]MaterialMaximum Allowable VOC Contentgrams/liter (lb/gal)Solvent for Coating Removal (Stripper) 200 (1.7)Solvent for Cleaning Operations 25 (0.21)Solvent for Bug and Tar Removal 25 (0.21)orBug and Tar Remover regulated under theCalif. Consumer Products Regulation (A)(A) Title 17 CCR, Sections 94507 - 9451711. All VOC-containing coating and solvent containers shall be kept covered when not in use.[Basis: SMAQMD Rule 459, Section 309.2]12. All cloth or paper used for surface preparation, cleanup and paint removal shall be disposed of in closedcontainers. Paper used for masking does not need to be disposed of in closed containers.[Basis: SMAQMD Rule 459, Section 309.1]13. Any end user of coating materials (e.g. autobody shops) shall not possess at any physical location withinthe District any containers containing coatings that are not in compliance with Condition Nos. 9 and 10.[Basis: SMAQMD Rule 459, Section 308]14. No motor vehicle and/or mobile equipment coating used at this facility shall contain hexavalent chromiumor cadmium.[Basis: Title 17 CCR, Section 93112]15. A person shall not apply any coating unless one of the following application methods is used:A. Electrostatic application equipment.B. High Volume Low Pressure (HVLP) spray equipment.i. The spray gun shall be permanently labeled as a HVLP, orii. If the spray gun is not permanently labeled as a HVLP, then the end user shall demonstrate that thespray gun meets the HVLP definition in Rule 459, Section 224 in design and use. A satisfactorydemonstration shall be based on the manufacturer’s published technical material on the design ofthe gun and by a demonstration of the operation of the gun using an air pressure tip gauge from themanufacturer of the gun.C. Low Volume Low Pressure (LVLP) spray equipment.D. Brush or roll coating, dip coat, or flow coat.E. Any other application method that achieves a transfer efficiency equivalent to, or higher than, theapplication methods listed in Rule 459, Sections 305.1(a)-(d) as determined by the methods specified inRule 459 Section 504.9. Written approval from the <strong>Air</strong> Pollution Control Officer shall be obtained foreach alternative application method prior to use.[Basis: SMAQMD Rule 459, Sections 224, 305.1, and 504.9]PAGE 4 OF 9 PAGESREVOCABLE AND NON-TRANSFERABLEPERMIT NOS.: XXXXX
Page 1 and 2: Automotive, Truck and Heavy Equipme
Page 3 and 4: Materials for Vehicles - The requir
Page 5 and 6: 2. State Requirementsa. California
Page 7 and 8: Temporary Protective Coating 60 (0.
Page 9 and 10: Administrative/Recordkeeping Requir
Page 11 and 12: 4. New Source Review -- Emission Of
Page 13 and 14: - Supplied with manufacturer’s em
Page 15 and 16: 777 12th Street, 3rd Floor SACRAMEN
Page 17 and 18: Authority to Construct EvaluationA/
Page 24 and 25: Exhibit VI-BSample Authority to Con
Page 26 and 27: 777 12 TH STREET, 3 RD FLOOR SACRAM
Page 36 and 37: 777 12 TH STREET, 3 RD FLOOR (916)
Page 44: 777 12 TH STREET, 3 RD FLOOR (916)

Automotive Refinishing Policy Manual - Sacramento Metropolitan Air ...

Create successful ePaper yourself

Delete template?

Save as template?