Flo-Darâ¢ Sensor - Hachflow

More documents

Recommendations

Info

Installation3.2.2 Sensor installationCAUTIONPotential hearing loss risk. Hearing protection required. The level transducer emitsultrasonic sound energy when powered. Ear protection must be worn whenworking within 1 meter of this device. Do not point the transducer output towardsears during installation, calibration and maintenance.ATTENTIONRisque de perte auditive. Protections auditives requises. Une fois activé, letransducteur de niveau émet une énergie ultrasonore. Des protections auditivesdoivent être portées lors de toute intervention à moins d’un mètre de cet appareil.Ne pointez pas la sortie du transducteur vers des oreilles lors d’opérationsd’installation, d’étalonnage et de maintenance.WARNINGExplosion hazard. Installation of equipment into hazardous locations must be doneso that no friction can be generated between the Flow Meter and any surroundingsurfaces (Figure 1 on page 8).ATTENTIONRisque d’explosion. L’installation de l’équipement dans des zones dangereusesdoit être effectuée de sorte qu’aucun frottement ne soit provoqué entre ledébitmètre et toute surface environnante (Figure 1 de la page 8).Mount the Flo-Dar sensor above the open channel on the wall of the manhole. A pole isavailable for retrieval of the Flo-Dar sensor without entry into the manhole.For temporary installation, an optional Jack-bar is available (see Accessories onpage 41). Instructions are included with the Jack-bar.14
InstallationThe Flo-Dar sensor dimensions are shown in Figure 5 and Figure 6.Figure 5 Flo-Dar sensor dimensions1 Optional extended depth sensor 3 Minimum clearance for cable2 Minimum clearance for cable with extended depth sensor15
Page 1: DOC026.53.00786Flo-Dar SensorOpen C
Page 4 and 5: Table of contents2
Page 6 and 7: SpecificationsSurcharge conditions
Page 8 and 9: General informationElectrical equip
Page 10 and 11: General informationFigure 1 System
Page 12 and 13: General information10
Page 14 and 15: Installation3.2 Mechanical installa
Page 18 and 19: Installation1 Minimum clearance for
Page 20 and 21: Installation3. Position the other t
Page 22 and 23: InstallationFigure 9 Wall installat
Page 24 and 25: InstallationFigure 11 Vertical alig
Page 26 and 27: Installation3.2.2.7 Make a final al
Page 28 and 29: Installation3.2.3 Measure the senso
Page 30 and 31: Installationaccomplished by touchin
Page 32 and 33: Operation30
Page 34 and 35: Maintenance5.1 Preventative mainten
Page 36 and 37: Maintenance5. Refill the canister t
Page 38 and 39: Maintenance36
Page 40 and 41: Replacement Parts and Accessories38
Page 42 and 43: Contact Information6. Write the SRN
Page 44: Limited warranty42

Flo-Darâ¢ Sensor - Hachflow

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?

Flo-Darâ¢ Sensor - Hachflow