Flo-Dar™ Sensor - Hachflow

Installation3. Position the other two clamp halves around the front end of the frame as shown inFigure 8.Note: In most cases the front of the frame will point toward the wall as shown in Figure 8 (seealso Figure 12 on page 23). If flow conditions require the sensor to point away from the wall,use the 12-inch spacer and position the two clamp halves around the back end of the frame.4. Connect the clamp halves together with four bolts. Lightly tighten the bolts totemporarily hold the clamp in position.Figure 8 Clamps assembled on wall bracket and frame1 Adjustable wall bracket 5 Frame2 Clamp half, threaded 6 Spacer3 Clamp bolt, ¼–20 x 1 in. 7 Wall mount bracket4 Clamp half, not threaded18