Flo-Darâ¢ Sensor - Hachflow

More documents

Recommendations

Info

Installation1 Minimum clearance for cableFigure 6 <strong>Flo</strong>-Dar sensor with SVS dimensions16
The dimensions of the standard frame for wall installation are shown in Figure 7.Installation1 22.8 in. with 2¼ in. spacer; 32.6 in. with 12 in. spacerFigure 7 Standard frame dimensions3.2.2.1 Assemble the clamps on the frame and wall bracketInstall the clamps on the frame and wall mount bracket before installation on the wall.Prerequisites• Frame• Wall mount bracket• Clamps• Hardware—wall bracket, spacer, nuts and boltsProcedure1. Position two clamp halves (one with threads and one without threads) around the wallmount bracket as shown in Figure 8.2. Connect the clamp halves together with four bolts. Lightly tighten the bolts totemporarily hold the clamp in position.17
Page 1: DOC026.53.00786Flo-Dar SensorOpen C
Page 4 and 5: Table of contents2
Page 6 and 7: SpecificationsSurcharge conditions
Page 8 and 9: General informationElectrical equip
Page 10 and 11: General informationFigure 1 System
Page 12 and 13: General information10
Page 14 and 15: Installation3.2 Mechanical installa
Page 16 and 17: Installation3.2.2 Sensor installati
Page 20 and 21: Installation3. Position the other t
Page 22 and 23: InstallationFigure 9 Wall installat
Page 24 and 25: InstallationFigure 11 Vertical alig
Page 26 and 27: Installation3.2.2.7 Make a final al
Page 28 and 29: Installation3.2.3 Measure the senso
Page 30 and 31: Installationaccomplished by touchin
Page 32 and 33: Operation30
Page 34 and 35: Maintenance5.1 Preventative mainten
Page 36 and 37: Maintenance5. Refill the canister t
Page 38 and 39: Maintenance36
Page 40 and 41: Replacement Parts and Accessories38
Page 42 and 43: Contact Information6. Write the SRN
Page 44: Limited warranty42

Flo-Darâ¢ Sensor - Hachflow

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?

Flo-Darâ¢ Sensor - Hachflow