13.07.2015 Views

CASTILE-B PELLET STOVE Owner's Manual Models:

CASTILE-B PELLET STOVE Owner's Manual Models:

CASTILE-B PELLET STOVE Owner's Manual Models:

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

RRCastile-B FS Pellet StoveCastile-B FS Pellet StoveE. Optional Log Set Placement InstructionsF. Thermostat InstallationCAUTIONLogs are FRAGILE. Use extreme care when handling orcleaning logs.2 PIECE LOG SET INSTALLATION1. Open door to expose the firebox.2. Install the left log first and then the right log. Figure 20.13. Lean the logs against the cast iron brick in the back ofthe firebox.4. Push the logs to the far left and far right against thesides of the firebox. Figure 20.2.5. To clean the logs, use a vaccum cleaner and a softbrush attachment or a paint brush.1. A 12 volt AC thermostat is required to operate this pelletappliance. You may use the included wall mount thermostator purchase an optional programmable thermostator remote control. It is equipped with an adjustableheat anticipator. The current rating is .05 amps. Theanticipator needs to be adjusted to the lowest settingavailable.2. When mounting a thermostat on a wall, be sure to followyour thermostat installation instructions carefully.NOTE: Thermostat must be mounted level foraccurate readings. The thermostat should bemounted on an inside wall and not in direct linewith the appliance convection air.NOTE: If the thermostat is located too close to theappliance, you may need to set the temperaturesetting slightly higher to maintain the desiredtemperature in your home.3. There is a 4 screw terminal block located on the backlower right corner of the stove directly above the powercord inlet. The center 2 screws are for the thermostatwires.CautionShock hazard.• Do NOT remove grounding prong from plug.• Plug directly into properly grounded 3 prong receptacle.• Route cord away from appliance.• Do NOT route cord under or in front of appliance.FUSEFuseTERMINAL BLOCKCENTER 2 SCREWS FORTHERMOSTAT WIRESFigure 20.1POWER OUTLETFigure 20.2NOTE:Due to the abrasive nature of a pellet appliance fire, thelogs are not covered under warranty. Any placement variationother than shown here can cause excessive heat andshall void the appliance warranty.Figure 21.1Page 20 7021-130D January 21, 2013January 21, 2013 7021-130D Page 21

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!