triad® electronic ballasts - Conserve-A-Watt Lighting, Inc

SpecificationsTYPICAL SPECIFICATIONSFOR RAPID START BALLASTS1. Ballasts (1-4 lamp) shall operate as a Parallel Circuit, allowing remaining lamps(s) to maintain full light outputif one or more lamps fail (except T12 High Output).2. Ballasts shall operate from 60 Hz input source of 120, 277 Volts, and sustained variations of± 10% (Voltage & Frequency) with no damage to the ballasts.3. Ballasts shall be a high frequency electronic type, and operate lamps at a frequency above 20 kHz.4. Lamp Current Crest Factor (ratio of peak to RMS current) shall be 1.7 or less in accordance with lampmanufacturer recommendation and ANSI C82.11-1993.5. Ballasts shall comply with FCC Part 18 Non-Consumer Equipment for EMI (power line conducted) andRFI (Radiated).6. Ballasts shall provide transient immunity as recommended by ANSI C62.41-1991, Location A2.7. Ballasts shall operate lamps with no visible flicker (