triad® electronic ballasts - Conserve-A-Watt Lighting, Inc

DCL ControlsDCL CONTROLSMODELDESCriptionLP12DCLUNV-xx Circuit Control PanelSC20DCLUNV Single Circuit ControllerRSMDCL51 Contact Interface ControllerWTPDCL51 Time/Photo ControllerWPS5527K Photo Sensor for WTPDCLxx = number of circuits (03-12)LP12DCLUNV-xxDimensions MountingLength 32” 24”Width 20” 16”Depth 4.3”The same cabinet size is usedfor the four different panels. thequantity of individual controllersinstalled is determined by themodel number.SC20DCLUNVDimensionsLength 9.66”Width 3.98”Depth 3.21”Mounting patternCircuit control panels are used to send commands down the lighting circuit to the DemandFlex ballasts. TheLP12DCLUNV-xx panels are available with 3 to 12 integral circuit control modules. If more than 12 circuits arebeing controlled, additional panels can be used.The SC20DCLUNV is used when there are a small number of circuits or space limitations prevent the use ofan LP12DCLUNV panel.One RSMDCL51 or WTPDCL51 can control up to 63 circuits. If more than 63 circuits are to be controlled, anRSMDCL can be connected in parallel with either controller for another 63 circuits.Stand Alone Time Clock/Photo CellContact Closure Interface ControlDCL ControlsThe WTPDCL51 controller provides time of dayscheduling and can also be connected to theWPS5527K Photo Cell for daylight harvesting.Manual override switches are also available.The RSMDCL51 controller integrates with externalrelays or switches to translate commands to the DCLsystem. This controller can be used to interface withbuilding automation systems, PLC’s, or switches.These systems may also incorporate photo cells fordayllight harvesting.PAGE 3-8FOR MORE INFORMATION CALL1-800-BALLAST(225-5278)