JDMFG_CATALOG_Full__15I
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Foam Insulated Curved Wall Inlet<br />
J&D Manufacturing’s Curved Wall Inlets have double wide, foam filled insulated chambers for maximum energy<br />
efficiency. Unlike conventional metal inlets that allow cold air to drop prematurely, J&D Curved Wall Inlets have<br />
a distinctive aerodynamic door design to bring air into your house toward the peak to effectively mix the air.<br />
Manual Door Latches<br />
Features<br />
• NEW! Molded one-piece side frames snap easily into the top and bottom of the frame.<br />
No more corners!<br />
• NEW! Molded door support in side frame to prevent infiltration of air and light<br />
• Foam filled inlet door is twice as thick for increased insulation<br />
• Curved “European style” door design to enhance performance<br />
• Air is jettisoned along the ceiling toward the center of the house<br />
• Ideal for air mixing in wider houses<br />
• Delivers significantly more CFM than galvanized inlets to reduce<br />
the number of required inlets by nearly half<br />
• Sealed inlet door:<br />
- Continuous top rubber cushion<br />
- Continuous bottom rubber pivot hinge<br />
- Nylon sweeps on sides of inlet door<br />
• Manual door latches secure door when not in use<br />
• Corrosion resistant<br />
• Shipped fully assembled and ready to install<br />
• May be cleaned with a high pressure washer<br />
• Exterior wind deflector recommended to optimize inlet performance<br />
and protect from direct sunlight for maximum inlet life<br />
Continuous<br />
rubber cushioned<br />
Continuous<br />
solid rubber pivot hinge<br />
Nylon Sweeps<br />
ENERGY<br />
EFFICIENT<br />
Cut away<br />
showing<br />
model with<br />
foam filled<br />
insulated<br />
curved door<br />
___________________________________________________________________________________________<br />
Part# Description<br />
CFM @ .10 SP Rough Opening Color<br />
___________________________________________________________________________________________<br />
IWP1322F Curved Wall Inlet, Foam Filled Chambers, with Cable Kit Pack, Assembled<br />
1,415 22½” W x 13½” H White<br />
___________________________________________________________________________________________<br />
IWP1344F Curved Wall Inlet, Foam Filled Chambers, with Cable Kit Pack, Assembled<br />
2,830 44½” W x 13½” H White<br />
J&D can make the IWP series inlet in any width up to 120” on special<br />
6200 Highway 12, Eau Claire, WI 54701<br />
ph. 800-998-2398 • fax. 888-972-4454<br />
JD13A_1213<br />
ph. 715-834-1439 • fax. 715-834-3812<br />
www.jdmfg.com • e-mail: jdmfg@jdmfg.com
Change language