Operating Manual LUXOR S 400
Operating Manual LUXOR S 400
Operating Manual LUXOR S 400
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
9 Maintenance and repair<br />
Maintenance work <strong>LUXOR</strong> S <strong>400</strong><br />
Installation<br />
� Carry out installation in a logical, reverse order.<br />
� Guide the capillary sensor and spring [2] with the capillary line into the heater. Fix the end of the<br />
spring with the screw [3].<br />
NOTE<br />
Make sure that the capillary line is not bent in any way and is not trapped by the screw.<br />
Connecting the temperature limiter: See “Circuit diagrams“ on Page 95.<br />
� Disconnect the dry air generator from the power supply.<br />
� Attach the rear panel of the unit.<br />
9.5.6 Replacing the adsorption agent (drying agent)<br />
WARNING!<br />
NOTE<br />
NOTE<br />
DANGER TO HEALTH!<br />
The activated adsorption agent generates heat in contact with water.<br />
Burns to the skin and drying out of the skin may occur.<br />
The dust may also cause respiratory problems.<br />
There is a danger of irritation of the eyes.<br />
� Wear protective gloves.<br />
� Wear a respirator.<br />
� Wear safety goggles.<br />
Observe the safety datasheet on the absorption agent (drying agent/molecular sieve)<br />
in “Safety instruction, adsorption agent“ on Page 93 .<br />
Disposal of the adsorption agent<br />
Used adsorption agents may contain impurities. Dispose of used adsorption agents<br />
as special waste in accordance with local regulations.<br />
Fig. 9.8 – Replacing the adsorption agent<br />
[1] Filler opening cover<br />
[2] Insulation<br />
[3] Protective enclosure<br />
[4] Adsorption agent<br />
54 Edition: August 2005