Cable and adapter manual

. Set PG/PC interface
This step is important fort he following software
� SIMATIC Step© 7 Manager (v5.2 + SP1)
� Windows Control Center (WinCC) (v6.0)
� Windows Control Center flexible 2004 (WinCC flexible) v5.2.0.0
� ProTool/Pro (v6.0 + SP2)
� Microwin
If the software you are using is not in the list above you can skip setting up the
PG/PC interface.
1. Open the system configuration by using the start
menu.
2. Click on „Set PG/PC interface“.
3. A Dialog with a list box named „Interface Parameter
Assignment Used:” appears. This box should offer
some „PC - Adapter” and/or „TCP/IP” (if you
want to use RFC1006) entries. If you cannot
find these entries go ahead with the steps
PC Adapter or TCP/IP otherwise skip these
steps.
PC - Adapter(Auto, MPI, PROFIBUS)
4. Click on „Choose“ to add these entries to the
PG/PC interface configuration.
5. In this dialog you can deinstall every
installed construction set and install the entries in the „Selection“ box. Choose
„PC - Adapter“ from the „Selection“ box on the left side and click on „Install“. The
chosen construction set will be
installed and a question appears
which asks you to use the
„MPI“ access for the PLC used.
Click „Yes“ if you want to use
the „MPI“ communication type.
Otherwise click „No“ (e.g. if you
want to use the
“PROFIBUS“ communication
type).
Page 16 Cable and adapter manual © by PI 2009