Cable and adapter manual

h. Microwin v4.0 using the PPI Multimaster mode
Please be sure that the interface configuration is correct as described
in point b
The PPI Multimaster mode has been developed for the purpose that multiple devices
can communicate parallel with one PLC. The following steps describe how to
configure this mode.
1. The cable must be set to PPIMulti mode. Therefore go to the „Config” menu.
2. Set it to „PPIMulti“ with the cursors of the cables case and press return to confirm
this configuration. The menu „Messages” (first menu) displays now „PM“ in the
first line.
3. Now you have to set the PG/PC interface. You can do this by using the Microwin
software. Start the Microwin software.
4. Click on „Set PG/PC Interface“ at the left side of the applikation window. See the
picture on the right for further details.
5. Choose the entry „PC/PPI cable(PPI)“ and click on „Properties”.
6. In the registry path „PPI“ you can for example the „HSA“.
Page 32 Cable and adapter manual © by PI 2009