Cable and adapter manual

g. Microwin v3.2 (only for S7 200)
Please be sure that the interface configuration is correct as described in point b
1. Start the Microwin software by using the desktop link or the
program entry in the start menu.
2. Click on „Type“ in the menu „PLC”. Configure the „PLC
Type“ (e.g. „CPU 224“) as well as the „CPU Version“ (e.g.
„01.22”) to the dialog.
3. Click on „Communications...” to start the next dialog. In the sector „Address” set
up the „Remote” listbox with the station address of the PLC (e.g. „2”).
Page 30 Cable and adapter manual © by PI 2009