Cable and adapter manual

PROFIBUS configuration
11. The register card „Local Connection“ offers
you the possibility to choose the COM –
Port and to configure the speed of the MPI
cable. Select the virtual COM – Port
created by the PLC - VCom. Now configure
to the list element „Transmission
rate“19200.
12. Select the entry „PC - Adapter(PROFIBUS)“ and click on „Properties“.
13. Set in the registry card „Locale connection“ the
„Connection to:“ parameter to the one simulated
by your PLC - VCom software. (e.g. „COM3“).
Below you can set the „Transmission Rate:“ to
„19200“.
14. Choose the registry card „PROFIBUS“and set
the „Transmission Rate:“ to „187,5kbit/s“. Set the
„Profile:“ to „DP“ („Decentral Peripherie“).
15. Save your settings by pressing the „OK“button
and close the opened „Set PG/PC -
interface“ dialog.
Page 18 Cable and adapter manual © by PI 2009