2017-2018-Mercer-Marine-Catalogue

Steering,Controls & Cables
LINK ARM KIT
Fits Johnson and Evinrude
42-061R ......................SA27361P ......................136.00
SPLASHWELL MOUNT KIT
42-062R ......................SA27253P ......................237.00
CLAMP BLOCK KIT (O/B)
42-059R ......................SA27055P ......................140.00
INBOARD CLAMP KIT
42-245R ......................SA27578P ......................133.00
ALUMINUM SUPPORT TUBE
42-064R ......................SA27274P ........................34.00
TRANSOM SUPPORT MOUNT KIT
42-058R ......................SA27256P ......................229.00
New Installation:
Measure cable routing path from wheel center line to engine
connection, as follows :
A = Center line of wheel to gunwale (or deck, if routed downward),
B = Dash to transom,
C = Gunwale to centerline of cable connection at centered tiller.
CABLE GUARD
This guard provides protection against salt and sand
corrosion to your QC cable steering rod.
42-250R......................SA-39329P .......................17.95
Installation Guidelines for Teleflex Rotary Mechanical Steering Systems
CLEVIS KIT
42-060R ......................SA27314P ........................61.50
For Cable installations through the Engine Tilt Tube: Add A, B & C + 6”,
and round up to the next foot. Order that cable length.
For Cables Mounted to Transom, Splashwell or Stringer: Add A, B & C,
then subtract 6” and round up to the next foot. Order that length
cable.
C
B
A
How to Measure SSC62 Steering Cables from Teleflex
Replacement of Existing Cable
If possible, find part number stamped on the plastic jacket of the old cable. If you removed the old cable, measure for the replacement cable
as follows:
“Y” in inches
For Rotary Steering Cable Replacement, Measure Existing Cable as follows: Measure plastic cable jacket (“Y” dimension, shown in above drawing)
in inches, add 18” and round up to the next foot. Order that length cable..
72 Contact us at 709-466-7430 or visit us online at www.mercersmarine.com