22.06.2020 Views

the Aviation Dictionary

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

resultant flux . reverse polarity welding

resultant flux - The flux in a magnetic circuit of an

aircraft magneto. Resultant of the flux of the rotating

permanent magnet and the flux that surrounds the

primary windings when primary current is flowing.

resultant lift - The vector sum of the magnitude and

direction of all of the lift forces produced by an airfoil.

resultant relative wind - In rotorcraft, airflow from

rotation that is modified by induced flow.

resume normal speed - Used by ATC to advise a pilot

that previously issued speed control restriction; are

deleted. An instruction to "resume normal speed" does

not delete speed restrictions that are applicable to

published procedures of upcoming segments of flight,

unless specifically stated by ATC. This does not relieve

the pilot of those speed restrictions that are applicable

to FAR91.117.

resume own navigation - Used by ATC to advise a

pilot to resume his own navigational responsibility. It is

issued after completion of a radar vector or when radar

contact is lost while the aircraft is being - radar vectored.

retard -To

slow or delay the progress of something.

retard breaker points - An auxiliary set of breaker

points in a magneto equipped with the Shower of

Sparks starting system. These points are operative only

during the starting cycle and open later than the run, or

normal, points. This provides a late or retarded spark.

Also referred to as retard points.

retard points - An auxiliary set of breaker points in a

magneto equipped with the Shower of Sparks starting

system. These points are operative only during the

starting cycle and open later than the run, or normal,

points. This provides a late or retarded spark. Also

referred to as retard breaker points.

retarder - A slow-drying solvent used to prevent

blushing or to provide a more glossy finish by allowing

the finish a longer flow-out time.

retention - There are five principles that promote deep

learning and enhance retention of course material:

praise stimulates remembering, recall is promoted by

association, favorable attitudes aid retention, leaming

with all the senses is most effective, and meaningful

repetition aids recall.

retentivity - The ability of a material to retain its

magnetic properties.

retina - The photosensitive portion of the eye, made up

of cells called rods and cones, that is connected to the

optic nerve.

retirement schedule -A list of limited life parts and the

times when they must be replaced. This list records the

part, serial number, time installed, and removal time.

retort - A laboratory vessel with a long tube used to

distill substances by heat.

Aircraft Technical Book Company

P.O. Box 270

Tabernash, CO 80478

http:llw.ACTechbooks.com

retract - To pull in or draw back.

retractable gear - This is a pilot controllable landing

gear system, whereby the gear can be stowed alongside

or inside the structure of the airplane during flight.

retractable landing gear - Landing gear that folds into

the aircraft structure to reduce parasite drag.

retraction test - The portion of an aircraft inspection in

which the airplane is put on jacks and the landing gear

cycled through its retraction and extension sequences.

retread - In tire recapping, a tire that has been renewed

to serviceable condition. Tires that meet injury

limitations can be recapped. Retreading or recapping

means reconditioning of a tire by renewing the tread, or

renewing the tread plus one or both sidewalls.

- . .

retreating blade - In rotorcraff. any blade, located in a

semicircular part of the rotor disc, where the blade

direction is opposite to the direction of flight.

retreating blade stall - In rotorcraft, a stall that begins

at or near the tir, of a blade in a helicopter because of

the high anglesA of attack required to compensate for

dissymmetry of lift. In a gyroplane the stall occurs at

20 to 40 percent outboard from the hub.

retrofit - To furnish something with new or modified

parts or equipment not available or considered

necessary at the time the part was manufactured.

return flow - The upper branch of a thermal circulation.

return stroke - Lightning that is visible to the eye and

marks the path of the positive charge of the step leader

back into the clouds.

return to service - The completion of all applicable

maintenance records and forms after maintenance has

been verformed on an aircraft that will allow the

aircraft to be legally flown.

revalidate - To confirm, sanction or make socething

valid again.

-

reverse bias - The polarity relationship between a

power supply and a semiconductor that does not allow

conduction of current.

reverse idle - A power lever position where the thrust

reversers are deployed, but engine power is idle.

reverse pitch - An angle to which the propeller blade

can be turned in order to provide reverse thrust from

the propeller.

reverse polarity welding - In electric arc welding,

reverse polarity occurs when the electrode is positive

and the- work is negative. The opposite is

called straight polarity. Straight polarity puts more heat

into the work piece, while reverse polarity minimizes

the heat in the work ~iece.

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!