PCD-Customs-Tools

Continuous cutting edges and a positive cutting edge geometry ensure the best
Results. Suitable for all CNC milling machines and hand routers (shaft diameter
note).
High-quality diamond blades ensure long tool life even in "difficult"
Materials & can be resharpened several times.
With the radius milling cutters, different run-out angles of the radii can be defined
become. Depending on the run-out angle, it should be avoided that there is a milling
track on the workpiece can emerge. The quality of the cut is better for radius milling
cutters with peripheral cutting edges than with spherical milling cutters that mill in the
3D area.
The reason is the higher cutting speed and the continuous cutting edge.
These milling cutters are often used in the manufacture of furniture fronts
Milling quality Reach a high level so that there is no need to rework by grinding.
When used in abrasive materials with a corundum content such as
Floor coverings can be a type of diamond with increased hardness used, this
must be specified when ordering.
A radius milling cutter that only mills in MDF often lasts significantly longer than one
Radius cutter that cuts abrasive materials, so it makes sense to choose the diamond
type To adapt the application.
Important NOTE:
Especially with customers, the diamond milling cutters for fire protection panels for
ventilation, chimneys etc.
we noticed that the customers mill at too high speeds, and as a result, they have to
cope with increased wear on the milling cutters. That's why it is essential to reduce
the speed by 1000-3000 1 / min and check whether the Heat development is reduced
if the cutting edge is still good.
Other sizes, shapes, radii and graduated prices on request -
shop@pkdsonderwerkzeuge.de