UC4™ Total Control™ Quick Guide - NORAC Systems
UC4™ Total Control™ Quick Guide - NORAC Systems
UC4™ Total Control™ Quick Guide - NORAC Systems
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
ACTIVE ROLL SYSTEMS<br />
An additional target rod is used on Active Roll systems. The following<br />
includes additional details for mounting and adjusting the second rod.<br />
• Before installing or adjusting, ensure sprayer is level and the booms are<br />
level.<br />
• The spring target should cross directly below the sensor centerline<br />
(Figure 7).<br />
• The frame target should be located 1/2" off the centerline (Figure 7).<br />
• Trim spring target flush with the central axis of the sensor (Figure 8).<br />
• Both the spring and frame target should be perpendicular (90°) to the<br />
central axis of the sensor (Figure 8).<br />
• Ensure the sensor view of the ground is not obstructed by anything<br />
other than the targets (e.g. hydraulic hoses from the wheel motor or the<br />
lower parallel lift arm).<br />
- a 12" diameter clear view of the ground is usually sufficient.<br />
Figure 6 – 47XX Active Roll Setup<br />
28