UC4™ Total Control™ Quick Guide - NORAC Systems

More documents

Recommendations

Info

Figure 7 – Active Roll Rod and Sensor Details for a John Deere 47XX (Front View) Sensor Alignment Tube NOTE: Spring target cut 2” past alignment tube Figure 8 – Active Roll Rod and Sensor Details for a John Deere 47XX (Side View) 29 NOTE: Both targets are perpendicular to sensor axis
7 QUICK REFERENCE 7.1 ISSUES DURING SYSTEM SETUP Table 4 – During System Setup (Install or ReTune) Symptom See Section See Page • During Control Panel Power Up Wrong number of sensors shown 4.2.1 10 Number of sensors are "Absent" 4.2.1 10 "Scanning" or ">>>>" stuck on display 4.2.1 10 • During Wiring Test "Wiring!" Displayed 4.1.3a) b) ,5.1 9, 21 Control panel displayed "OK" but the wrong boom moved 4.3.3 14 Control panel displayed "OK" but the boom moved wrong direction 4.3.3 14 Booms do not move 4.3.1, 4.3.7 14, 16 • During Sensor Detect "SN=0 det" "Retry" displayed 5.1 21 "Too Many" "Retry" displayed 5.1 21 "SNR xxxx" "Retry" 4.2.5 13 Stuck at "Exit Cab" "push"… 4.5.1, 4.5.2, 4.5.3 19, 19 • During Boom Geometry Tuning Timeout Error at "LftDet" or "RgtDet" 4.3.3 a), b), 4.3.8 14, 17 Timeout Error at "MlfDet" 4.3.3 a), b), c) , 4.3.8 14, 17 Timeout Error at "MrlDet" 4.3.2a), b), 4.3.8 14, 17 Timeout Error at "DZ Stp 1" 4.3.3 a) 14 Timeout Error at "KP Stp 4" 4.3.3 a) 14 Timeout Error at "Adj 255" 4.3.3 a) 14 Timeout Error at "Adj 4" 4.4 18 "Too High" or "Too Low" message 4.2.3 a), 4.3.3 a-3) 11, 14 "Backwards" "Retry" displayed 5.1 21 30
Page 1 and 2: UC4 Total Control Canada NORAC Sy
Page 3 and 4: TABLE OF CONTENTS 1 INTRODUCTION...
Page 5 and 6: 2 OPERATOR SAFETY DANGER STEP 1: Al
Page 7 and 8: Table 1 - Examples of Normal Operat
Page 9 and 10: 3.5 CHANGING THE SYSTEM SENSITIVITY
Page 11 and 12: 4 COMMON SYMPTOMS AND SOLUTIONS •
Page 13 and 14: 4.1.6 • Boom does not appear to b
Page 15 and 16: 4.2.2 continues c) Protective Weath
Page 17 and 18: 4.3 HYDRAULIC RELATED ISSUES • De
Page 19 and 20: 4.3.5 • Boom(s) creep up or down
Page 21 and 22: 4.4 BOOM INSTABILITY AND MAIN LIFT
Page 23 and 24: 4.5.4 • Main section tends to low
Page 25 and 26: ↓SNR 2521↓ ⇒ ↓Retry ?↓ Ex
Page 27 and 28: height lower than -9 inches. It is
Page 29 and 30: 6.2 PASSIVE ROLL SYSTEMS The follow
Page 31: ACTIVE ROLL SYSTEMS An additional t
Page 35 and 36: Symptom See See Section Page Boom(s
Page 39 and 40: Statement of Limited Warranty NORAC

UC4™ Total Control™ Quick Guide - NORAC Systems

Create successful ePaper yourself

Delete template?

Save as template?