USER'S GUIDE - ShipWeight

Weight Monitoring
2.11 Reports and documentation
2.11.1 Standard reports
From the Project menu you can select Report setup… to specify the options
for a standard report.
The report setup dialog has a work breakdown tree where selections can be
made on which weight groups should be included or not in these weight
reports. When the reports are run, the filter dialog has extended capabilities
for filtering; the general filter dialog has been added on a separate tab-sheet
in the report filter screen, and is opened by the browse button.
Selection can be made to decide which weight
groups are to be included in the weight reports
The user can decide which columns to be included in the report. In a list
window inside the Wgt.grp. frame VCG, LCG, TCG, Aft and Fore are listed
and selected. This means that the report will include columns containing
values for these quantities. By selecting or unselecting the quantities in the
list, the user can decide whether to include or exclude them in the reports.
The Wgt.Grp. frame also contains checkboxes for Comment, Sum and SFI
code. Selecting Comment will make reports include comments tagged to the
different weight groups (using the Log dialog). Selecting Sum will make
reports with summarized lines after each level instead of setting the report up
in a hierarchical way as default. Checking the SFI code box will include
corresponding SFI codes in the report in addition to the weight group codes.
In the area Report values the user can choose which weight groups to include
in the report. The options are: All, Defined and Lowest. Selecting Lowest will
make reports only with weight groups at the lowest level where values exist.
This means that the summarized weight groups will be excluded.
2-47
ShipWeight – User’s Guide, version 10.0, April 2011
A general filter has been added to the filter screen
of the standard reports