laboratory catalogue - Wenk Lab Tec

1
2
7. Heating and cooling technology
Heating/Water baths
Internal
dimensions
(W x D x H)
706
External
dimensions
(W x D x H)
1
Water Level Regulator for Water Baths 1002-1013
Adjustable, to keep the water level constant and to cool Water Baths
1002-1013 (approx. 3°C above tap water temperature).
Also see shaking water waths.
E & OE.
www.wenk-labtec.com
GENERAL CATALOGUE 2010/11
Type PK Cat. No.
1919 1 9.905 986
2
Steam Bath 1023
For gentle simmering using Erlenmeyer flasks, bottles, etc. Bath, ring aperture cover
GFL
and perforated floor above the heating element are made of stainless steel.
Temperature range from approx. 5°C above ambient to boiling point, with temperature control by thermostat. Heating
element protected by overtemperature cut-out. The adjustable water level regulator at the back of the unit and the
set of rings are supplied as standard.
With removable, square cover (W 265mm x L 265mm) accommodating a 9-part set of rings, in heat-resistant plastic,
which can be split. The aperture diameter can be adjusted in approx. 20mm steps (min. 32.5/max. 173.5 mm). The
bath housing is made of powder coated, electrolytically galvanized sheet steel. Mains supply 230V 50/60 Hz, 1.0 kW
(Other voltages available on request).
The unit is tested according to the German Equipment Safety Law and has the CE mark.
Capacity Power Weight PK Cat. No.
mm mm litres W kg
240 x 240 x 120 342 x 342 x 180 7 1000 9 1 9.905 923
3
4
Type Apertures
with
sets
of rings
Top
dia.
mm
1031
6
90
1032
8
110
* Alternative voltages available on request!
3
Test Tube Rack 1933
Accessory for Steam Bath 1023.
Stainless steel, test tube rack, with 100 x 18mm diameter apertures.
Type PK Cat. No.
1933 1 9.905 993
Support Rod 1985
Accessory for Steam Bath 1023.
Stainless steel support rod, 316 x 12mm length x diameter.
Type PK Cat. No.
1985 1 9.905 995
4
Water Baths for Fume Hoods 1031 and 1032
Special baths for gentle simmering with Erlenmeyer flasks, bottles, etc., also suitable for
GFL
use in fume hoods. Stainless steel bath, removable recessed lid with holes and
perforated floor above the heating element.
Temperature range from approx. 5°C above ambient to boiling point, with thermostatic temperature controller.
Heating element protected by over-temperature cut-out.
The apertures in the lid are covered by sets of rings in heat-resistant plastic. The adjustable constant level device at
the right-hand side of the unit is included.
The units are tested according to the German Equipment Safety Law and have the CE mark.
External
dimensions
(W x D x H)
Weight Working height PK Cat. No.
mm kg mm
430 x 300 x 155
670 x 300 x 155
6.1
8.2
100
100
1
1
GFL
GFL
GFL
9.905 931
9.905 932