parts identification

Step 5a
H108
75
Deck Assembly Insert
*NOTE: If Deck Boards (2) (38) DO NOT fit between Uprights (74) (75), as
stated on Step 5 of the manual, follow these steps.
1. Loosen 5/16" Hardware (H108) on Main Beams (67) that attach to Corner Uprights (74) (75) on
sides of the set. Make sure not to completely remove the Hardware (H108) from Corner Uprights
(74) (75). You may have to pull out on the Uprights to gain enough space for the Deck Boards to
fit between the Uprights.
2. After the Deck Boards (2) (38) are fitted between Uprights (74) (75) attach Deck Boards (1) (2) (38) to
Main Beams (67) using #8 Hardware (H152) as shown in the manual.
3. Tighten Hardware (H108) on Main Beams (67) that was loosened in #1.
4. Continue with #2 Step 5 in the manual to complete the Deck Assembly.
67
24a
38
2
74
INSIDE VIEW
OF SET
H108