Pipeline User's Guide - Telestream

Pipeline SC Shipping Container Contents
In addition to the Pipeline itself, each package contains the following:
• Software Installation and User’s Guide CD-ROM
• Power adapter with power cord
• Quick Start Guide (in CD case)
Pipeline Quad Shipping Container Contents
In addition to the Pipeline itself, each package contains the following:
• Software Installation and User’s Guide CD-ROM
• Power cords
• Quick Start Guide (in CD case)
Pipeline HD Dual Shipping Container Contents
In addition to the Pipeline itself, each package contains the following:
• Software Installation and User’s Guide CD-ROM
• Power cords
• Quick Start Guide (in CD case)
LOCATE THE PIPELINE SC
95881
Locate the Pipeline SC
Pipeline User’s Guide
For permanent locations, select a stable and level, smooth, hard surface. Avoid carpeted or cloth-covered
surfaces which inhibit airflow or reduce heat dissipation, which contributes to overheating. Select an
isolated area that provides a proper operating environment and protection from accidental damage to the
Pipeline. Route power, Ethernet, and other cables to protect users from a tripping hazard and damage to
the Pipeline.
LOCATE THE PIPELINE QUAD | PIPELINE HD DUAL
For permanent locations, mount the Pipeline Quad|HD Dual in a single rack-unit slot in a computer rack
and secure it in place. Make sure the following issues are adequately addressed:
Elevated Operating Ambient Temperature. If installed in a closed or multi-unit rack assembly, the
operating ambient temperature of the rack environment may be greater than room ambient. Therefore,
consideration should be given to installing the equipment in an environment compatible with the maximum
ambient temperature specified (Operating and Storage Temperature Parameters on page 6).
Reduced Air Flow. Installation of the equipment in a rack should be such that the amount of air flow
required for safe operation of the equipment is not compromised.
Mechanical Loading. Mounting of the equipment in the rack should be such that a hazardous condition is
not achieved due to uneven mechanical loading.
Circuit Overloading. Consideration should be given to the connecting equipment to the supply circuit and
the effect that overloading of the circuits might have on over-current protection and supply wiring.
Appropriate consideration of equipment nameplate ratings should be given when addressing this concern.
7