Pipeline User's Guide - Telestream

Canadian EMC Notice of Compliance
95881
Canadian EMC Notice of Compliance
Pipeline User’s Guide
This digital apparatus does not exceed the Class A limits for radio noise emissions from digital apparatus
set out in the Radio Interference Regulations of the Canadian Department of Communications.
Le present appareil numerique n'emet pas de bruits radioelectriques depassant les limites applicables aux
appareils numeriques de la classe A prescrites dans le Reglement sur le brouillage radioelectrique edicte
par le Ministere des Communications du Canada.
Important Safety Instructions
Before using Pipeline devices, read the following safety instructions to ensure it is used safely:
• Unplug the device before cleaning.
• Use only a lightly-dampened cloth to clean the unit; never pour liquids onto the device.
• Do not place the device on an unstable surface or near extreme heat.
• Do not stack Pipelines more than two units high to avoid over-heating.
• Use only the power source supplied, and recommended in this manual.
• Connect all electronic equipment to properly grounded power outlets.
• Telestream recommends using surge protection equipment (may be feature of a UPS).
Caution
Pipelines contain no user serviceable parts. Never open the chassis
enclosure. Doing so without express permission from Telestream may
void your warranty.
EN55022 Class A Warning
In a domestic environment this product may cause radio interference in which case the user may be
required to take adequate measures.
Regulatory Approved Standards for Electrical Safety
This equipment complies with the minimum requirements of these standards:
IEC950 (or EN60950/BS7002/VDE0805 May 1990)
UL1950
CSA C22.2-950-M89
Radiation Emission Susceptibility Regulatory Approved Standards
This equipment complies with the minimum requirements of these standards:
FCC155, Class A
EN55022, Class A
EC DIR 89/336/EEC
EN50082-1
iii