SB-C 5/10-2 Wso (Fp) - Kärcher

Basic setting chemicals
Set adjustment cover to 2%.
Remove the service tool and reconnect
the hose to the washing area to the distributor
block air.
Repeat the setting of the dosing valves
air for the remaining washing areas.
Note
After performing the basic setup, the consistency
of the foam should only be
changed by adjusting the dosing valves air.
Controls
If no faults are present, nothing will be
shown.
Note
To acknowledge faults see "Fault assistance"
Open the menu "customer settings"
Press OK button for more than 2 seconds.
Press the RIGHT button.
1 Output air
2 Distributor block water/chemicals
3 Water/chemicals dosing valve
4 Output water/chemicals
5 Distribution block air
6 Dosing valve air
Open fresh water supply.
Remove the hose at the distribution
block water/chemicals outlet and replace
with a 400 mm hose piece (PVC
hose 6/4).
Use wash programme "Foam wash" for
this washing area.
Set the fluid stream from the hose piece
by adjusting the dosing valve water/
chemicals to 300 ml/min (measure with
measuring cylinder).
End wash programme "foam wash".
Remove the hose piece and reconnect
the hose to the washing area.
Repeat the setting of the dosing valves
water/chemicals for the remaining
washing areas.
Basic setting air
1 Key "1/ON"
2 Control lamp operating state
3 Display
4 LEFT key
5 RIGHT key
6 OK button
7 ESC button
During normal operating mode, the control
panel display alternates between:
Day of the week, date, time, summer time
(Som)/winter time (Wint)
Press the OK button.
The menu "customer settings" (see following
page) has been reached.
Operating time of the system on the current
day
1 Pressure reducer
Set pressure reducer to 0.25 MPa (2.5
bar).
Use the service tool 6.901-074.0 between
the output on the distributor block
air and the hose to the washing area.
Use wash programme "Foam wash" for
this washing area.
Adjust the dosing valve air so that the
pressure gauge of the service tool displays
0.15 MPa (1.5 bar).
End wash programme "foam wash".
Maintenance work due from customer service
(example).
If more than one maintenance procedure is
required, these will be shown in sequence.
If no maintenance procedures are required,
nothing will be shown.
Fault occurred (example).
If more than one fault is present, these will
be shown in sequence.
The number in parentheses shows the total
number of faults present.
English 43