dB - Operator's Manual - John Deere

28 EN
On closing:
– check that the collector channel (8) is properly fitted
onto its support (9) and resting on the right-hand
guide;
– put the lever (3) into the «R» position and lower the
cover (1) to the height of the levers (3) and (6);
– first put the lever (6) into its housing followed by
lever (3). Lower the cover in line with the fastening
screw.
! WARNING! When the cover (1) has been
lowered check that:
– he channel exit (8) is correctly lined up with the
opening in the rear plate (10) and that it is resting
on the support (11).
Then:
– fully tighten the fixing nut (5);
– put the lever (6) into the notch at position «7»;
– take the blocks (2) away, and reassemble the knob
on the lever (3) and the access hatch (4).
6.3 PROGRAMMED MAINTENANCE
MAINTENANCE
7 6
The following table is to help you maintain your machine’s safety and performance.
It shows the main maintenance and lubrication operations and their frequency. To the
right of each item, there is a box where you can write the date or after how many operating
hours the work was carried out.
! WARNING! All checks, adjustments and replacements not described in
chapters 6.4 and 6.5 of this manual must be carried out by your Dealer or a
specialized Service Centre. Both have the necessary knowledge and tools to
ensure that the work is carried out correctly without affecting the safety of the
machine.
10
8
10
11
8
9
8