You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
36 EN<br />
PROBLEM SITUATION LIKELY CAUSE SOLUTIONS<br />
4. Starting<br />
is difficult or the<br />
engine runs<br />
erratically<br />
5. Weak engine<br />
performance<br />
during cutting<br />
6. The engine<br />
stops but the<br />
light flashes<br />
7. The engine<br />
stops and the<br />
light goes off<br />
8. The engine<br />
stops but the<br />
light stays on<br />
9. Uneven cut<br />
and poor grass<br />
collection<br />
Key in «ON»,<br />
engine running<br />
Key in «ON»,<br />
engine running<br />
Key in «ON»,<br />
engine running<br />
Key in «ON»,<br />
engine running<br />
Key in «ON»,<br />
engine running<br />
Key in «ON»,<br />
engine running<br />
– fuel fault<br />
– forward speed too high<br />
in relation to cutting height<br />
– the safety devices cut in<br />
Electronic card in safety alert,<br />
due to:<br />
– earthed micro-switches<br />
– flat battery<br />
– overload caused by the charge<br />
regulator<br />
– badly connected battery<br />
(poor contact)<br />
– engine badly earthed<br />
– problems in the engine<br />
– cutting deck not parallel<br />
to the ground<br />
– blade cutting badly<br />
TROUBLESHOOTING<br />
– clean or replace the air filter<br />
– flush out the float chamber<br />
– empty fuel tank and refill<br />
with new fuel<br />
– check and, if necessary,<br />
replace fuel filter<br />
– reduce the forward speed<br />
and/or raise the cutting<br />
deck<br />
– check that the conditions<br />
allowing starting are met<br />
(see page 24/b)<br />
Put the key in the «OFF»<br />
position and look for the<br />
cause of the problem:<br />
– check connections<br />
– recharge battery<br />
– contact a Licensed Service<br />
Centre<br />
– check battery connections<br />
– check engine earth<br />
connection<br />
– contact a Licensed Service<br />
Centre<br />
– check tyre pressures<br />
– re-align the cutting deck<br />
to the ground<br />
– check that the blade<br />
is fitted properly<br />
– sharpen or replace<br />
the blade<br />
– check the tension<br />
of the belt