Serie UTBS - Soler & Palau Sistemas de Ventilación, SLU

Constant pressure operation
• Check that the transmitter output signal type jumper (mA/V) in the voltage position (factorysetting).
• Configure the DIP switches as indicated in the table below:
DIP switch ON / OFF Notes
DIP 1 - Not used
DIP 2 - Not used
DIP 3 - Not used
DIP 4 OFF Pressure mode (Pa)
DIP 5
Select according to the required damping time:
0,4s (OFF) / 10s (ON)
DIP 6 OFF Minimum output voltage 0V
ENGLISH
• Set the pressure range: Press the “OK” button and move to the required range using
buttons “” and “” . Finally press “OK” again to save the configuration. The pressure ranges
which may be selected are as follow: -50...+50 Pa; 0...+100 Pa; 0...+150 Pa; 0...+300 Pa;
0...+500 Pa; 0...+1000 Pa; 0...+1600 Pa; 0...+2500 Pa.
Constant flow operation
Only available with the TDP-D model.
In this mode of operation the pressure transmitter converts the pressure differential (∆P) to a
flow (qv) based on the following equation:
q v
=k √∆ P
• Place the transmitter’s output signal type jumper (mA/V) in the voltage position (factory
setting).
• Configure the DIP switch as indicated in the table below:
Microswitch DIP ON / OFF Notes
DIP 1 - Not used
DIP 2 - Not used
DIP 3 - Not used
DIP 4 ON Flow mode
DIP 5
Select according to the required damping time:
0,4s (OFF) / 10s (ON)
DIP 6 OFF Minimum output voltage 0V
53