ASP - Alcad

ASP software manual5.4.2. Restore configurationThis option is used to restore the previously saved confi guration of a device ormodule. It is similar to the copy option described above but works only with the sameequipment whose confi guration has been saved, since the serial numbers must bethe same.Note: With both copying and restoring, the data loaded into the device or module will be those of the input andthe output parameters. It may be that in some cases, depending on the type of module, it is necessary to open oneor other of the confi guration menus for the module to be confi gured correctly.5.5 - Changing the configuration fileIf you wish to modify the parameters of the LNB so that they agree with those your areusing in your installation, you can do so via the LNB menu (on the main screen of the ASPsoftware) by selecting LNB Oscillators.A window will appear in which you can set different values for the oscillators according tothe band. You can thereby confi gure the value which corresponds to your LNB. By default,the most common values are confi gured, i.e. those shown in the previous illustration.6. NETWORK INFORMATION TABLEWhen the whole installation has been confi gured and saved in a fi le, the ASP softwareoffers you the possibility of generating a Network Information Table (NIT) and of loading itinto the modules of the installation. On the main screen of the ASP, an indicator shows thestatus of the NIT of each of the devices.Grey: Module without NIT tableGreen: Module with correct NIT tableENG ASP software manual - 39