Samsung Moniteur 85" - Tactile préassemblé - 430 cd/m² - QM85D-BR (LH85QMDRTBC/EN ) - Manuel de l'utilisateur 3.33 MB, pdf, Anglais

Optimum Picture Quality and Afterimage
Burn-in Prevention
Optimum Picture Quality
••
Due to the nature of the manufacturing of this product, approximately 1 pixel per million (1ppm)
may be brighter or darker on the panel. This does not affect product performance.
--
The number of sub-pixels by panel type: 6,220,800
••
Run Auto Adjustment to improve the picture quality. If noise is still found even after auto
adjustment, adjust Coarse or Fine.
••
Leaving the screen fixed on a stationary image for an extended period of time may cause afterimage
burn-in or defective pixels.
--
Activate power-saving mode or a dynamic screen saver if you will not be using the product for
an extended period of time.
What is afterimage burn-in?
Afterimage burn-in should not occur when the LCD panel is operating normally. Normal operation refers
to a continuously changing video pattern. If the LCD panel displays a fixed pattern for an extended period
of time (more than 12 hours), a slight voltage difference may occur between the electrodes in pixels that
control the liquid crystals.
Such a voltage difference between electrodes increases with time and makes the liquid crystals thinner.
When this occurs, a previous image can remain on the screen when the pattern changes. To prevent this,
the accumulated voltage difference should be reduced.
――
Afterimage burn-in should not occur when an LCD panel is operating in proper conditions.
Source
Black Matrix
Drain
Common
Electrode (ITO)
Color-Filter
Prevention of Afterimage Burn-in
Setting the anti-screen burn-in pattern
The anti-screen burn-in pattern automatically operates in standby mode.
••
Disabling the anti-screen burn-in pattern
On the remote control, press 2 → 2 → 7 → CH → 0.
If the remote control sensor blinks once, the pattern is disabled.
TFT
Data Bus-Line
Gate
Pixel Electrode (ITO)
Storage
Capaccitor (Cs)
••
Enabling the anti-screen burn-in pattern
On the remote control, press 2 → 2 → 7 → CH → 0.
If the remote control sensor blinks twice, the pattern is enabled.
――
When the screen is turned off, the anti-screen burn-in pattern will operate for two hours.
――
Keeping the anti-screen burn-in pattern on requires extra power consumption.
121