instruction manual and warranty rules instructions d ... - DT Swiss
instruction manual and warranty rules instructions d ... - DT Swiss
instruction manual and warranty rules instructions d ... - DT Swiss
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
3 INSTALLATION<br />
3.1 GENERAL INFORMATION<br />
CAUTION<br />
Please take note of the following safety advice for the assembly.<br />
• To fasten bolted connections, always use a torque wrench in the appropriate torque range specified by <strong>DT</strong> <strong>Swiss</strong>, by the<br />
headset-manufacturer or the stem-manufacturer.<br />
• Please note the maximum <strong>and</strong> minimum torque while fastening the parts. The lowest value is authoritative, but the torque<br />
should not go below the lowest value given by <strong>DT</strong> <strong>Swiss</strong>.<br />
• Your <strong>DT</strong> <strong>Swiss</strong> fork can have a straight steerer with a diameter of 28.6mm (1 1/8“) or a tapered steerer with a diameter of<br />
39.82mm (1.5") at the bottom <strong>and</strong> 28.6mm (1 1/8“) at the top. Please only use a headset which is compatible with your<br />
steerer diameter.<br />
• Do not use any steerer adapters or reducer bushings.<br />
• Your <strong>DT</strong> <strong>Swiss</strong> fork is built for a stem clamp without thread. Do not add any holes or threading, or make any kind of technical<br />
alternations to the fork.<br />
• Be careful not to damage the steerer or the crown when assembling or using your <strong>DT</strong> <strong>Swiss</strong> fork. Pay special attention when<br />
fitting the headset crown race to the base of the steerer tube. The parts mounted on your fork should have no sharp edges.<br />
• Do not use cotter style stems<br />
• The flange of the discontinuous clamp area of the stem must be at least 7mm high.<br />
CAUTION<br />
The spacers used between the headset <strong>and</strong> the stem when assembling, must not under-run the minimal height of 5mm or<br />
exceed the maximal height of 30mm.<br />
The steerer clamp of the stem must not be larger than 45mm.<br />
A 5mm spacer must be applied above the stem, to guarantee that the whole clamping length of the stem rests on the steerer.<br />
Make sure, that there is a big enough gap between the top edge of the spacer <strong>and</strong> the steerer, so you can adjust the play of<br />
your steerer correctly (<strong>DT</strong> <strong>Swiss</strong> recommends 2-3mm)<br />
6