2j - Gilera Bi4
2j - Gilera Bi4
2j - Gilera Bi4
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
The coolant should be replaced every two years as follows:<br />
Maintenance<br />
- remove the two drain screws, located on the water pump cover<br />
and the cylinder respectively (Fig . 14 - no. 1 and 2); when the<br />
radiator plug is unscrewed, the coolant will flow out of them . To<br />
complete drainage, lean the cycle over to the right;<br />
- when the system is empty, replace the screws;<br />
- refill with AGIP PERMANENT FLUID, covering<br />
the radiator tubing ;<br />
- idle the engine to eliminate any air pockets<br />
in the circuit and top off the level, which<br />
.must total 0.900 liter of coolant;<br />
- tighten the plug make sure there are no<br />
leaks with the cycle erect, which could only<br />
be due to overfilling.<br />
Removing<br />
the seat<br />
To remove the seat, pull out on the two release levers (Fig. 15 no.<br />
A) , unhook the pins (B) from the tailpiece and lift up.<br />
53