Montage- und Gebrauchsanleitung Universal Anschlagpunkt 115

5. Fitting the universal anchorage point
5.4 Fitting to a fixed vertical ladder with a Hailo or Haca fall protection rail
IMPORTANT: The operating licence will be
revoked and all warranties on the part of manufacturer
invalidated if this device is not handled in
accordance with these instructions (i.e. improper
assembly or fitting, surface damage, etc.).
The components supplied for fi tting the universal
anchorage point allow it to be fi tted to a fi xed
vertical ladder with fall protection rails of different
manufacturers.
The location plate is secured to the rung using
additional components with the fall protection rail.
If a fall protection rail fi xture is already in place
where the location plate needs to be fi tted, the
existing fi xture must be removed and replaced
according to the assembly steps 1-4.
Installation example:
The universal anchorage point is fi tted to 3 ladder
rungs using various fi xtures together with the
fall protection rail.
1) 3 ladder rungs are fi rst reinforced using a
rung repair kit [1].
Push a tube [1a] into each rung and secure it on both
sides with an adjusting screw [1c] and countersunk
screw M16x50 [1b].
Torque to be applied to screws: 80 Nm
2) Position the location plate [2] on these 3 rungs
from behind. Together with the fall protection rail,
the location plate is secured to the rungs using
3 mounting sets [4].
Torque: 20 Nm
3) Fit the anchorage point [3] to the location plate
(M16x50 bolts, DIN 933, property class 8.8 [5]).
Torque: 210 Nm
4) In addition to this, the fall protection rail is secured to
the next rung above and the next rung below the
location plate using a mounting set [4].
Ensure that the specifi ed
tread widths are observed.
X = min. 150 mm
When carrying out the annual inspection of the
anchorage point, the bolts and screws must be
checked to ensure that they are screwed tight.
32
Instructions for fitting and use • Universal anchorage point • Revised 2013-11/GB/02