DSR 9900 PVR - Radix

GB
11.9 Data Transfer
This is intended to transfer the channel information on one
receiver to another receiver of the same model / version.
You can also transfer channel information from your PC to a
receiver.
1. Receiver to Receiver (STB - STB)
Use a RS232C cable (cross type, "0-modem") to connect both
receivers.
Go the Main Menu, select "Channel Manager" and then select
menu option "Data Transfer".
Select "Sender (Set to Set)" for the receiver that will send the Cable Pin Configuration
channel data.
(1) o --------- o (1)
Select "Receiver (Set to Set)" for the receiver that will receive (2) o --------- o (3)
the channel data.
(3) o --------- o (2)
Press the OK button on both receivers to start the transfer.
(4) o --------- o (4)
"Sending" appears on the sending receiver and "Receiving" (5) o --------- o (5)
appears on the receiving receiver.
The transfer progress bar shows the progress of the channel data transmission. When the
transfer is completed, "Complete" appears.
You can check that the channel data on the Slave and Master receivers are the same.
2. PC to Receiver (PC - STB)
You will need a suitable software to be able to transfer the channel information from a receiver to
your PC and vice versa. This software will be provided upon request.
Please visit RADIX website www.radix-sat.de
Use a RS-232C cable (cross type) to connect the Receiver to your PC.
In your PC programme set your PC as "Sender (Set to Set)". "Sender" signifies the device that is
transmitting the channel information.
On the receiver go the Main Menu, select "Channel Manager" and then select menu option "Data
Transfer".
Set your receiver as "Receiver (STB