Manual - Tracker

Tracker G400
Tracker G400 is a GPS (Global Positioning System) device that positions itself with the help of satellites and
sends the information to a mobile phone that is running Tracker Hunter® software.
1.1 GSM antenna
1.2 Led lights
1.3 Switch button
1.4 GPS antenna
1.1
1.2
1.3
1.4
2.1
When you start using Tracker G400, you should first charge the battery.
Charging
1. Place the charger connector in the socket. 3.1
30
2.2
The red light 1.2 is lit to show the device is charging. The charging may take up to seven hours if the battery
is empty at the beginning.
2. When the charging is complete, the green light 1.2 goes on.
NOTE!
Use only the original charger. A wrong charger may damage the device.
Charging is permitted in the temperature range of +10C - +30C.
Charge the battery fully before using device for the first time. This will help ensure maximum capacity and lifecycle
of the battery.
Led lights
NOTE!
constant red � device is charging
constant green � battery fully charged
green light on for a few seconds � device starting up
red light on for a few seconds � device switching off
red and green flashing in turns every
3 seconds
3.1
3.2
� device searching for GPS satellites
green light flashes every 3 seconds � satellites located and device ready to
use
red light flashes with 1 second
frequency
red light flashes three times per
second
� battery low
� batteri almost empty or SIM faulty,
missing or locked with PIN code
When the device is on, the led lights indicate the GPS operations. If the GPS is set to Off, the led lights flash only
when the device needs the GPS information from satellites, e.g. when position is requested.