Manual - Tracker
Manual - Tracker
Manual - Tracker
Sie wollen auch ein ePaper? Erhöhen Sie die Reichweite Ihrer Titel.
YUMPU macht aus Druck-PDFs automatisch weboptimierte ePaper, die Google liebt.
Alarms<br />
Geofence (Area alarm)<br />
By giving the radius of a circle you can create a permitted area around given location of the device. If device<br />
leaves the circled area an alarm message informing this is sent to the user.<br />
Go to Targets > List all > Dogs > (name of the target) and choose Menu > Alarms > Set geofence. Then set the<br />
center coordinates (Type in the coordinates, or choose the position of the cursor, the position of the target or Your<br />
own position), the geofence radius and alarm interval (=time how often the device checks if it is in the permitted<br />
area or not). Press Send.<br />
In case device exits the permitted area the device sends max. 20 alarm messages to the user. After that, if the<br />
target re-enters the area and leaves again, the device will send another 20 messages. If the GPS of the device is<br />
Off it will automatically turn On if the device exits the permitted area and will be On according to the interval set for<br />
the Geofence.<br />
Bark detector<br />
The device includes a bark detector and bark calculator. Bark calculator encloses into each location message the<br />
number of barks. Bark volume has four default values, which are adjusted from the <strong>Tracker</strong> Hunter®.<br />
To set the bark detector sensitivity choose Targets > All targets > Dogs > (name of the target) > Configuration<br />
commands > Set bark sensitivity. If the bark calculator does not work properly, try another bark sensitivity.<br />
The barking interval is shown in the map view in the top bar, above the dog‟s icon or you can go to map view with<br />
the target chosen, then press Targets > Target info. Or you can see it in the messages, Menu > Messages.<br />
The device also includes bark/silence alarm. The alarm sends a message to the hunter device when the bark<br />
interval is below/above preset values.<br />
To set the bark alarm, choose Targets > All targets > Dogs > Alarms > Set bark alarm. Now<br />
set time limit and rate limit of the bark. When the dog‟s barking frequency exceeds the value you set for it, in the<br />
time period you set, you will receive an SMS notifying the dog has started barking. When the barking frequency<br />
decreases below the values, you will receive another notification.<br />
NOTE!<br />
Bark detector may be influenced by external sounds, like branches hitting the device. Therefore, the device may<br />
detect barking when the dog is not actually barking. If the bark detector does not function well, change the bark<br />
detector sensitivity.<br />
43