Manual - Tracker

Targets menu
Icons vary according to the displayed target. As a default target on the programme is My Position. Under icons
There are listed other targets under icons. If you do not have targets there, there is only All targets-command,
under which you can see all the target types. By choosing one type you can add or remove targets. By choosing
Menu, you enter the Target‟s own menu. By choosing Show you can see target on the map, which makes the
target a displayed target. After that the icons of the Targets menu change to match to the displayed target.
Icons of the Targets menu
GPS You can start, stop or change the GPS connection. This icon shows
when e.g. My Position is the displayed target.
Start realtime tracking starts realtime tracking. This icon shows
only when target has a GPS-tracking device.
Locate shows the latest postition of the displayed target on the
map.
Target info. Information on the last position from the device, such as
satellites‟, barking and battery status.
Show the target on the map (target becomes Displayed target) .
Displayed target is as default your own mobile (My position). The
dog , friend or a position you desire to see on the map must
be first added as a target to the programme. Then it can be
chosen as the displayed target.
By selecting this icon, you enter the Target menu.
Target (My position/dog) menu
The icons of the menu vary according to the target. When the target is a collar, the menu shows e.g.
several icons related to tracking. In th menu of My position, there are fewer functions.
Icons of the Target menu
Navigate to starts navigation to the displayed target. The selected target
turns into a Navigation Target.
Live. Manage settings which are needed to use Tracker Hunter®
(sharename, passwords, position sharing). This icon is shown only
when the target is my position.
Call the device and listen to barking
Show the target on map or on compass (target becomes
Displayed target) or see the target info.
Target settings. Settings of the target which are needed to use
Tracker Hunter® (sharename, passwords, phone number etc.)
Configuration commands sends configuration commands to the
tracking device and manages e.g. GPS-power, A-GPS settings
and barking sensitivity of the device and re-starting the device.
Tracking commands tracking period and length as well as single
positioning by sending orders to the device. Tracking functions
independently whether you have Tracker Hunter® on or not. You
cannot start a new tracking until the previous one has ended or it
has been ended from the same phone number where it had been
started from.
40