SDM-9220/9230 - Comtech EF Data

More documents

Recommendations

Info

SDM-9220/9230 Hardware Installation Guide 7.1 GSM A-bis/A-ter Optimization • Voice: - FR - EFR - HR - AMR 16K - AMR 8K • Data: - GPRS (CS-1 to CS-4) - EDGE (MSC-1 to MSC-9) - HSCSD • Signaling: - 16K - 32K - 64K - Concentrated and Non-Concentrated • Fax, modem • Short Message Service (SMS) • Dual Rate • Auto-detection of time slot assignments • DS0 Cross connect • SS7 FISU spoofing for A-ter signaling. 7-2 Memotec Inc.
7.2 Voice Channels Networking Features • Voice compression algorithms: ACELP-CN (8K/6K), G.729/G.729A (8K), G.711 (PCM 64K), G.723 (low 5.3K/high 6.4K), G.726 (ADPCM 16K/24K/30K/40K) • Dialing: Multi-Frequency (MF), Dual Tone Multi-Frequency (DTMF) or Pulse • Line activation: dedicated or switched • Fallback: buffering scheme for packetization of DSP packets: Compression Packetization Fallback (Buffering) ACELP-CN 8K and 6K (configurable) G.723 6.4K and 5.3K (configurable) up to 5 up to 3 G.726 16K 16K none G.726 24K 24K none G.726 32K 32K none G.726 40K 40K none G.729, G.729A 8K up to 8 PCM64K 64K up to 2 Table 7-1: Packetization of DSP packets • Signaling: E&M 4w/2w (Type I, II and V) Immediate Start, Wink Start; Loop Start and Ground Start FXS (OPX) and FXO (SLT), ISDN-BRI, ISDN-PRI, QSIG, custom signaling; software configurable • Voice/fax line impedance: 600/900 ohms or complex • Echo cancellation: CCITT G.165 • Fax Relay: Group III FAX 4.8, 7.2, 9.6, 12.0, 14.4 Kbps, over PowerCell. Super G3 configurable to passthrough or fallback to G3. Group IV fax and other nonvoice bearer ISDN channel at 64K • Fax signal types: V.21 channel 2, V27ter 2400 bps, V27ter 4800 bps, V29 7200 bps, V29 9600 bps, V33 12000bps, V33 14400bps, V17 7200bps, V17 9600bps, V17 12000bps, V17 14400bps • Modem Relay: V.32bis demodulation up to 14.4 Kbps, modem passthrough (G.711) for other modem types • Encoding: Mu-law or A-law Memotec Inc. 7-3
Page 1 and 2:
NetPerformer ® SDM-9220/SDM-9230 H
Page 3 and 4:
Contents Chapter 1: Preface. . . .
Page 5 and 6:
4. 11 Powering the Unit . . . . . .
Page 7 and 8:
9.4.1 Configuring the E&M-PTT Physi
Page 9 and 10:
List of Figures Location of Product
Page 11 and 12:
List of Tables Compatible Telecom S
Page 13 and 14:
Preface 1 Memotec Inc. 1-1
Page 15 and 16:
1.1.3 Sales Contacts Preface • Al
Page 17 and 18:
1.2.2 Audience Preface This documen
Page 19 and 20:
1.3 Changes to Console Operations P
Page 21 and 22:
1.4.3 Product Work Order Number Pre
Page 23 and 24:
Preface 1.6 Notice Concerning Hyper
Page 25 and 26:
Compliance Information 2 Memotec In
Page 27 and 28:
2.2 Compliance and Regulatory State
Page 29 and 30:
2.2.2 Marking Compliance Informatio
Page 31 and 32:
With Interface Cards P/N 100-1111-0
Page 33 and 34:
Compliance Information If so, you w
Page 35 and 36:
2.2.9 Industry Canada Statements Co
Page 37 and 38:
2.3 Environmental Information 2.3.1
Page 39 and 40:
2.3.3 Compliance to China RoHS Comp
Page 41 and 42:
Unpacking 3 Memotec Inc. 3-1
Page 43 and 44:
3.1.3 Distance Requirements Unpacki
Page 45 and 46:
3.2 Preparing the Site 3.2.1 What Y
Page 47 and 48:
Hardware Installation 4 Memotec Inc
Page 49 and 50:
4.2 Opening the Chassis Casing NOTE
Page 51 and 52:
4.3 Installing or Upgrading the DSP
Page 53 and 54:
4.3.1 Removing a DSP Module Hardwar
Page 55 and 56:
4.5 Removing an Interface Card Hard
Page 57 and 58:
4.6.2 Setting the NT/TE Mode Hardwa
Page 59 and 60:
Hardware Installation NOTE: An E1-7
Page 61 and 62:
Hardware Installation Caution: The
Page 63 and 64:
Slot 1 Slot 2 Slot 3 (on SDM-9230 o
Page 65 and 66:
4.8 Installing the Unit in a Rack H
Page 67 and 68:
4.9 E&M Wiring and Grounding Hardwa
Page 69 and 70:
4.9.1 E&M Grounding Considerations
Page 71 and 72:
Hardware Installation 3. Allow no m
Page 73 and 74: Plastic connector SDM-9220 DC or SD
Page 75 and 76: Hardware Installation Stage PWR ST
Page 77 and 78: 4.12.2 Activating the Console Conne
Page 79 and 80: 4.14 Connecting the LAN Hub Hardwar
Page 81 and 82: Product Description 5 Memotec Inc.
Page 83 and 84: 5.2 Optional Hardware Product Descr
Page 85 and 86: a. Product Description Green The ap
Page 87 and 88: 5.4.3 LAN Cables Product Descriptio
Page 89 and 90: 5.6 Power Supply Product Descriptio
Page 91 and 92: 5.8 DSP Modules 5.8.1 DSP-160 Modul
Page 93 and 94: 5.9 Interface Cards Product Descrip
Page 95 and 96: FXO Interface Cards Product Descrip
Page 97 and 98: Product Description leads), and the
Page 99 and 100: Product Description Workaround: Sub
Page 101 and 102: ISDN-BRI S/T Interface Card Orderin
Page 103 and 104: 5.9.4 Interface Card Status LEDs Pr
Page 105 and 106: Intf. Card LED Color Indication Sin
Page 107 and 108: 5.9.6 E&M Interface Card Product De
Page 109 and 110: 5.9.7 T1/E1 and ISDN-BRI S/T Interf
Page 111 and 112: Adaptor Cable Product Description
Page 113 and 114: Serial Port and User Equipment Conn
Page 117 and 118: 6.4 WAN/User Port Specifications Se
Page 119 and 120: 6.5.4 X.21 EU Cables Serial Port an
Page 123: Networking Features 7 Memotec Inc.
Page 127 and 128: Troubleshooting Tips 8 Memotec Inc.
Page 129 and 130: Console connection does not work, w
Page 131 and 132: E&M-PTT Interface Card 9 Memotec In
Page 133 and 134: 9.2.1 Specifications E&M-PTT Interf
Page 135 and 136: To connect this cable: V G E&M-PTT
Page 137 and 138: Air-ground- Air radio PTT Answer Mo
Page 139 and 140: 9.4 Configuring Push To Talk E&M-PT
Page 141 and 142: SE/SLOT/#/ CHANNEL example E&M-PTT
Page 143 and 144: Index A Access methods 3-5 ACT LED
Page 145 and 146: console 5-8 dual serial 5-22 LAN 5-
show all

SDM-9220/9230 - Comtech EF Data

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?