SEALANTS & ADHESIVES - CH Reed Inc.

4
174
GRACO SEALANTS AND ADHESIVES EQUIPMENT ❚ 2K EQUIPMENT
Precision Dose
Dispense System
Hose/Applicator Module Selection (Code C)
The hose applicator module is comprised of an adhesive
hose, booster paste hose, 2K Ultra-Lite® dispense valve
and the necessary air tubing and cables. The module is
available with either a manual or automatic applicator,
and with hoses in 15 ft. (4.6 m) or 25 ft. (7.6 m) lengths.
Both the manual and automatic applicators include a 2K
Ultra-Lite dispense valve. The manual applicators have a
pistol-grip trigger kit added to the valve. This trigger
activates an electric switch that sends a signal back to the
controller to open the valve and start the pump.
Adhesive Hose
The adhesive hose is 3/4 in. ID to within 5 ft. (1.5 m)
from the dispense valve, where the width narrows to 1/2
in. ID. This hose is made of high-pressure syntheticrubber
core hose and is designed for use with moisturecure
materials.
Booster Paste Hose
The booster paste hose is a 1/4 in. ID PTFE core with a
stainless steel braid cover.
2K Ultra-Lite Dispense Valve
The 2K Ultra-Lite dispense valve is a disposable, airoperated
mixer-type valve that requires no flushing. The
valve has Severe Duty needles and seats, dual-lubricated
shaft seals and a snuff-back action that ensures a clean
cut-off and no dripping. In addition, the valve is
equipped with fittings, an inlet booster check valve, a
hose swivel, center-injection booster nozzle and a
removable outlet for cleaning. The outlet pieces are PTFEplated
for easy adhesive clean-up.
Electrical Voltage Selection (Code D)
Select either a 120 volt 50/60 Hz or a 230 volt Hz single
phase power as required.
(15A, 15M) 15 ft. (4.6 m)
Hose with automatic or manual valve kit
(25A) 25 ft. (7.6 m)
Hose with automatic or manual valve kit